Uline H-2564 Guia De Inicio Rapido

H-2564
8' A-FRAME
PICNIC TABLE
TOOLS NEEDED
7/16" (11 mm) Socket Bit
Power Drill
Seat Board x 2 Tabletop Board x 3
NOTE: It is important to keep the lag screws loose
throughout assembly. Tighten during step 6.
WARNING! Do not lean on tabletop or seats
when assembling.
1. Verify all parts are present before beginning.
2. Place the three A-Frame bases on a flat, level surface.
3. Place one seat board on each side of the A-Frame
bases. Align the pre-drilled holes over the middle of
the A-Frame base supports. Seat board should be
flush with the end of support.
Figure 1
PAGE 1 OF 6
1-800-295-5510
uline.com
Two Person Assembly
(Optional)
PARTS
Leg Brace Board x 1
ASSEMBLY
Pour le français, consulter les pages 5-6.
A-Frame Base x 3
4. Loosely attach seat boards to A-Frame base with the
3⁄" lag screws and washers using the power drill and
7/16" socket bit (will tighten later in step 6). (See Figure 1)
5. Place the three tabletop boards on the A-Frame bases.
Align the pre-drilled holes with the A-Frame base.
Loosely attach tabletop board slats to A-Frame base
with the 3⁄" lag screws and washers using the power
drill and 7/16" socket bit (will tighten later in step 6).
(See Figure 2)
6. Make sure the table is square and tighten all lag
screws.
Figure 2
Para Español, vea páginas 3-4.
Washer x 33
3⁄" Lag Screw x 33
0721 IH-2564