Test Passed; Test Failed; Interruption Of Travel - Switching Off The Vehicle; Retests - Dräger SCANIA Interlock 7x00 Serie Instrucciones De Uso

|
Use
4.5.2.1 With installed camera (optional)
● Hold handset with the display in the direction of the camera.
● Depending on the configuration, the blue LED within the camera may flash
when the handset is recognized.
● Depending on the configuration, a breath sample may only be possible if the
blue LED is flashing and the handset is recognized.
● Blow evenly into the mouthpiece as long as a continuous tone sounds.
4.5.2.2 With activated anti-circumvention (blow/suck) (optional)
● Blow evenly into the mouthpiece as long as a continuous signal tone
sounds, followed immediately (the signal tone ceases) without pause by
sucking hard until a short signal tone sounds.
● If the breath sample is not provided in the correct way with the blow and
suck breathing technique, Repeat test is displayed.
● Confirm with the OK button.
The instrument requests a repeated breath sample.
● If the breath sample flow is too hard or too soft, a corresponding message is
displayed.
● Confirm with the OK button.
● The instrument requests a repeated breath sample.
● After an adequate breath sample, the test result is displayed with Test
passed or Test failed.
4.5.3

Test passed

The measured breath alcohol concentration is below the set limit value.
● Test passed is displayed and the LED lights up green.
● The vehicle is authorised to start, Free Start Time: is displayed and a timer
specifies for how long the vehicle can be started.
● After starting, the instrument is in stand-by mode and Drive Safely! is
displayed.
● Attach handset to the holster again.
4.5.4

Test failed

The measured breath alcohol concentration is above the set limit value.
24
● Test failed is displayed and the LED lights up red followed by Next test in:
with a timer displaying the remaining disabled hours, minutes and seconds.
The LED remains lit until the instrument is ready to accept a further sample.
● After an intermediate phase indicated by Preparing for test, Ready for test
Please blow is displayed.
● Provide further breath samples if necessary.
4.6 Interruption of travel – Switching off the
vehicle
● As long as the vehicle engine is running after a successful breath alcohol
test, the instrument is in stand-by mode. This is displayed by Drive Safely!.
● When the vehicle ignition has been switched off or when the vehicle has not
been started after a successful breath test, a restart period starts. During
this time the vehicle can be started without a new breath alcohol test being
required. The display shows Free Start Time: and a timer of the remaining
time for starting the vehicle.
● When this time of the restart period has ended, the instrument is switched
off. The instrument remains switched off until it is activated again by turning
on the ignition.
If the restart period runs out, a new breath alcohol test must be given before
the vehicle can be restarted.
4.7

Retests

CAUTION
For safety reasons and due to certain road laws, the vehicle should be parked
off the road, away from traffic in safe position before presenting the retest.
There are (depending on instrument settings) several minutes available to
deliver the retest.
To make sure the driver stays sober while driving, the instrument requires
additional breath alcohol tests while driving (optional).
● The instrument makes a beeping sound, the blue LED flashes and Ready
for test Please blow is displayed.
Instructions for use | ®
SCANIA Interlock 7x00