Viewing Videos; Turn On The Power - JVC DLA-RS640 Guia De Inicio Rapido

Viewing Videos

STANDBY/ON LAMP
Remote Control
3
2
MODE 1 MODE 2 MODE 3
SETTING MEMORY
This unit
6
MEMO
WARNING
When you are using R, be sure to remove the lens cover.
0
Connect the power cord, and ensure that the "STANDBY/ON" indicator
0
lights up in red.

Turn on the power

1
Remote control: press the C [ON] button
R
Projector unit: press the A [STANDBY/ON] button
The "STANDBY/ON" indicator light switches from red to green (light
0
goes off after the unit starts up).
(P Q) The lens cover opens.
0
"STANDBY/ON" lights up (red)
1
In standby state
STANDBY/ON TANDBY ND
.
Choose the image to project
2
Remote control: press the [HDMI 1] or [HDMI 2] button
1 3
Projector unit: press the [INPUT] button to switch the input
Play back the selected device to project the image.
2
0
Turn off the power
3
Remote control: press the B [STAND BY] button
Projector unit: press the A [STANDBY/ON] button
While the "Are you sure you want to turn off?" message is displayed,
0
press the button again.
The lamp turns off, and the "STANDBY/ON" indicator switches from
0
a green light to a red blinking light.
After the light goes off, the fan will run for about 100 seconds to cool
0
down the lamp (Cool-down mode). Do not disconnect the power
cable while cooling is in progress.
After about 100 seconds, the "STANDBY/ON" indicator switches
0
from a blinking red to a solid red light.
"STANDBY/ON" blinking (red)
In the Cool-down mode
STANDBY/ON
.
For R, attach the lens cover manually.
0
For P Q, the lens cover closes upon power off.
0
CAUTION
The power cannot be turned off within approximately 60 seconds after it
0
has been turned on.
The power cannot be turned on again while cooling is in progress (100
0
seconds).
Pull out the power plug when the unit is not to be used for a prolonged
0
period of time.
If the indication of indicator differs from the description, refer to "Indicator
0
Display on the Main Unit"P. 10 for details.
"STANDBY/ON" lights up (green)
LAMP WARNING STANDBY/ON
"STANDBY/ON" lights up (red)
LAMP WARNING STANDBY/ON
During lamp startup
TANDBY ND LAMP WARNING
In standby state
TANDBY ND LAMP WARNING