Working With The Power Tool - Flex DD 2G 10.8-LD Instrucciones De Funcionamiento Originales

DD 2G 10.8-LD
Inserting the tools
CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch
(2) to the middle position.
Drill bits with a diameter of 1.5–10 mm,
¼" screwdriver bits and ¼" bit holders are
securely held in the chuck.
 Grip the power tool firmly with one hand
and turn the chuck with the other hand.
– Turn counterclockwise to open the chuck
further.
– Turn clockwise to close the chuck.
 Insert the tool.
 Close the chuck fully.
 Move the direction preselector switch to
the required position (left/right).
 Carry out a test run to check that the tool
is chucked in the centre.
Switching on the power tool
To switch the power tool on:
 Press the trigger switch.
The power tool trigger switch allows the
operator to increase the speed in
increments up to the maximum speed.
To switch the power tool off:
 Release the trigger switch.
NOTE
The power tool is equipped with a brake
–
which stops the cutting accessory as
soon as the trigger switch is released.
When using the power tool continuously,
–
the operator should work primarily with
the trigger switch fully depressed.

Working with the power tool

CAUTION!
Before carrying out any work on the
power tool, move the direction preselector
switch (2) to the middle position.
1. Insert the battery.
2. Insert the tool (drill bits, srewdriver bits,
bit holders).
3. Set torque preselection to the required
setting.
4. Set speed to the required setting.
5. Set the required direction of rotation.
6. Hold the power tool with one hand on
the handle and assume the working
position.
7. Switch on the power tool.
At the end of work:
8. Release the trigger switch.
9. Move the direction preselector
switch (2) to the middle position.
19