Fein KBE35 Manual De Instrucciones página 25

OBJ_BUCH-0000000296-001.book Page 25 Wednesday, February 7, 2018 3:47 PM
Symbol, character Explanation
Stops the motor
(**) may contain numbers and letters
Character Unit of measure-
ment, international
P
W
1
P
W
2
n /min, min
0R
r/min
in
inch
U
V
f
Hz
M...
mm
Ø mm
mm
Fe HM
mm
Fe HSS
mm
mm
kg
T
°C
a
L dB
pA
L
dB
wA
L
dB
pCpeak
K...
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
For your safety.
Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have thor-
oughly read and completely understood this
Instruction Manual and the enclosed "General
Safety Instructions" (document number
3 41 30 054 06 1). The documents mentioned should be
kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial safety
regulations.
Intended use of the power tool:
Magnetic core drill unit for drilling with core drill bits and
solid drill bits on materials with surfaces suitable for mag-
nets in weather-protected environments using the appli-
cation tools and accessories recommended by FEIN.
Unit of measure-
ment, national
W
W
-1
, rpm, rpm
inch
V
Hz
mm
mm
mm
mm
mm
mm
kg
°C
dB
dB
dB
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2 2
min, m/s
This power tool is also suitable for use with AC genera-
tors with sufficient power output that correspond to the
Standard ISO 8528, design type G2. This Standard is par-
ticularly not complied with when the so-called distortion
factor exceeds 10 %. When in doubt, please refer to the
generator instruction/specification guide.
These appliances are not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
Special safety instructions.
Wear personal protective equipment. Depending on appli-
cation, use face shield, safety goggles or safety glasses.
Where appropriate, wear dust mask, hearing protectors,
gloves and workshop apron capable of stopping small
abrasive or workpiece fragments. The eye protection
Explanation
Power input
Output
No-load speed
(clockwise)
Size
Rated voltage
Frequency
Size of metric thread
Diameter of a round part
Drilling capacity in steel - TCT (core drill bit)
Drilling capacity in steel - high speed steel (HSS)
(core drill bit)
Drilling capacity in steel - high speed steel (HSS)
(twist drill bit)
Max. drill chuck capacity
Weight according to EPTA-Procedure 01
Allowable ambient temperature
Sound pressure level
Sound power level
Peak sound pressure level
Uncertainty
Basic and derived units of measurement from the
international system of units SI.
en
25