Battery Disposal - Dremel 760 Instrucciones De Funcionamiento Y De Instalacion

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

SM 2610031419 02-13_SM 2610031419 02-13.qxp 2/28/13 2:41 PM Page 3
Do not attempt to disassemble
W RNING
the battery or remove any
component projecting from the battery
terminals. Fire or injury may result. Prior to
disposal, protect exposed terminals with heavy
insulating tape to prevent shorting.
Lithium-ion Batteries
If equipped with a lithium-ion battery, the battery
must be collected, recycled or disposed of in
an environmentally sound manner.
"The EPA certified RBRC Battery
Recycling Seal on the lithium-ion
(Li-ion) battery indicates Robert
Bosch
voluntarily participating in an industry program
If an extension cord is
W RNING
necessary, a cord with
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used. This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles
.
NoTe: The smaller the gauge number, the
heavier the cord.
1. The charger was designed to fast charge
the battery only when the battery temperature
is between 32˚F (0˚C) and 113˚F (45˚C). If the
battery pack is too hot or too cold, the charger
will not fast charge the battery. (This may
happen if the battery pack is hot from heavy
use). When the battery temperature returns to
between 32˚F (0˚C) and 113˚F (45˚C), the
charger will automatically begin charging.
2. A substantial drop in operating time per
charge may mean that the battery pack is
nearing the end of its life and should be replaced.
3. Remember to unplug charger during storage
period.
4. If battery does not charge properly:

Battery Disposal

Tool
Corporation
extension Cords
Important Charging Notes
to collect and recycle these batteries at the
end of their useful life, when taken out of
service in the United States or Canada. The
RBRC program provides a convenient
alterative to placing used Li-ion batteries into
the trash or the municipal waste stream, which
may be illegal in your area.
Please call 1-800-8-BATTERY for information
on Li-ion battery recycling and disposal
bans/restrictions in your area, or return your
batteries to a Skil/Bosch/Dremel Service
Center for recycling. Robert Bosch Tool
Corporation's involvement in this program is
part of our commitment to preserving our
is
environment and conserving our natural
resources."
ReCoMMeNDeD SIZeS oF exTeNSIoN CoRDS
120 VoLT aLTeRNaTINg CURReNT TooLS
Cord Size in a.W.g.
Tool's
ampere
Cord Length in Feet
Rating
25
50
3-6
18
16
6-8
18
16
8-10
18
16
10-12
16
16
12-16
14
12
a. Check for voltage at outlet by plugging in
some other electrical device.
b. Check to see if outlet is connected to a
light switch which turns power "off" when lights
are turned off.
c. Check battery pack terminals for dirt.
Clean with cotton swab and alcohol if
necessary.
d. If you still do not get proper charging,
take or send tool, battery pack and charger to
your local Dremel Service Center. See "Tools,
Electric" in the Yellow Pages for names and
addresses.
Note: Use of chargers or battery packs not
sold by Dremel will void the warranty.
-3-
Wire Sizes in mm
Cord Length in Meters
100 150
15
30
60
120
16
14
0.75 0.75 1.5
2.5
14
12
0.75 1.0 2.5
4.0
14
12
0.75 1.0 2.5
4.0
14
12
1.0 2.5 4.0
2
Tabla de contenido
loading

Tabla de contenido