Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SM 2610031419 02-13_SM 2610031419 02-13.qxp 2/28/13 2:41 PM Page 2
Read and understand all instructions. Failure to follow all instructions
W RNING
listed below, may result in electric shock, fire and/or serious personal injury.
IMPoRTaNT SaFeTy aND oPeRaTINg INSTRUCTIoNS
1. This manual contains instructions for
battery charger model 760-01. Do not
substitute any other charger.
2. Before using battery charger, read all
instructions and cautionary markings on
(1) battery charger, (2) battery pack, and (3)
product using battery.
3. Charge only Dremel rechargeable
batteries listed on page 4. Other types of
batteries may burst causing personal injury
and damage.
4. Charge battery pack in temperatures
above +32 degrees F (0 degrees C) and
below +113 degrees F (45 degrees C). Store
tool and battery pack in locations where
temperatures will not exceed 120 degrees F
(49 degrees C). This is important to prevent
serious damage to the battery cells.
5. Do not recharge battery in damp or wet
environment. Do not expose charger to rain
or snow. Water entering battery charger may
result in electric shock or fire.
6. Place charger on flat nonflammable
surfaces and away from flammable
materials when recharging battery pack.
Carpeting and other heat insulating surfaces
block proper air circulation which may cause
overheating of the charger and battery pack. If
smoke or melting of the charger or battery
pack is observed, unplug the charger
immediately and do not use the battery pack or
charger. Contact customer service immediately.
7. Make sure cord is located so that it will
not be stepped on, tripped over, or
otherwise subjected to damage or stress.
Damaged plug and cord may result in electric
shock or fire.
8. Disconnect the charger by pulling the
plug rather than the cord. Do not operate
charger with damaged cord or plug; have
When batteries are not in
W RNING
tool or charger, keep them
away from metal objects. For example, to
protect terminals from shorting Do NoT place
"SaVe THeSe INSTRUCTIoNS"
Charger Safety Rules
them replaced immediately. Damaged plug
or cord may result in electric shock or fire.
9. Do not insert battery pack in charger if
battery pack case is cracked. Using
damaged battery pack may result in electric
shock or fire.
10. Do not disassemble charger or operate
the charger if it has received a sharp blow,
been dropped or otherwise damaged in
anyway. Incorrect reassembly or damage may
result in electric shock or fire.
11. Before each use, check the battery
charger, cable and plug. If damage is
detected, do not use the battery charger.
Never open the battery charger yourself,
take it to a Dremel Factory Service Center,
or qualified serviceman only using original
spare parts. Incorrect reassembly may result
in electric shock or fire.
12.
recommended or sold by Dremel. Using
attachments not recommended may result in
electric shock or fire.
13. Do not store battery pack in charger.
Battery pack stored in charger over a long
period of time could lead to battery pack
damage and fire.
14. Unplug charger from outlet before
storage, attempting any maintenance or
cleaning. Such preventive safety measures
reduce the risk of electric shock or fire.
15. Keep the battery charger clean by
blowing compressed air on charger vents
and wiping the charger housing with a
damp cloth. Contamination may result in
electric shock or fire.
16. Replace battery pack if a substantial
drop in operating time per charge is
observed. Battery pack may be nearing the
end of its life.
Battery Care
batteries in a tool box or pocket with nails,
screws, keys, etc. Fire or injury may result.
Do NoT PUT BaTTeRIeS INTo FIRe oR
exPoSe To HIgH HeaT. They may explode.
-2-
Do
not
use
attachment
not
Tabla de contenido
