Troubleshooting - Klarfit Vibe 4DX Manual Del Usuario

TROUBLESHOOTING

Problem
The device cannot be
started.
The machine makes noises
during training.
The remote control does
not work.
The device stops suddenly.
The device does not work.
Display shows [ER01].
Display shows [ER02].
Possible cause
The power plug is not
plugged in.
The device is not switched
on.
The fuse is blown.
Normal noises generated
by the motor or the
abrasion between the
mechanical units.
The batteries are empty.
The remote control is too
far away from the unit.
The training time has
expired.
Too many commands were
sent to the device by the
remote control.
The motor's working
current is over 3A and
lasting for 3 minutes.
the other signal lines
except +/- lines disconnect.
Possible solutions
Plug the power plug into
the socket.
Turn the device on.
Check your fuses.
Noises during training
are normal and do not
constitute a defect in the
product.
Replace the batteries.
Move the remote control
closer to the unit.
Wait 10 minutes and then
restart.
Turn the unit off and
restart it.
Disconnect the power
supply,then Insert the plug
and restart.
Contact a specialist
company for inspection
and repair.
EN
41