Master MCI Manual De Uso Y Mantenimiento página 27

Assemble the two legs on the belt conveyor using a No. 6 hex key
6
electrical box on the side of the motor.
8
distance shown is approximately 780 mm.
780 mm aprox. Interior
Loosen the screws on the drive roller heads using a No. 6 hex key
10
without removing them completely.
The distance between the sheet metal edge of the leg to the ten-
7
sioner block must be 5 mm.
9
following image, present on both sides of each leg.
11
following image. Then, with the same spanner, turn the tensioning
screw until the desired belt tension is achieved.
www.masterproducts.es
27