Technical Information; Installation Considerations - Hansgrohe S 04447 0 Serie Instrucciones De Montaje

Tools Required / Outiles Utiles
/ Herramientas Útiles
2
English

Technical Information

Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate @ 44 PSI
*Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.

Installation Considerations

• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• This trim is for use with iBox Universal Plus model
01850181 (not included).
• To prevent scald injury, the maximum output
temperature of the shower valve must be no
higher than 120°F. In Massachusetts, the
maximum output temperature can be no higher
than 112° F.
• Adjust the rotational limit stop (see page 16)
during installation. Further adjustments may be
necessary due to seasonal water temperature
changes.
• Do not install a shut-off device on either
outlet of this valve. Use of such a device
can defeat the ability of the valve to balance the
hot and cold water pressures.
• The pressure balance trim with diverter is
suitable for a two-function installation, such as a
showerhead and tub spout, or showerhead and
handshower.
• For use with shower heads rated at 2.5
GPM (9.5 l/min) or higher.
• Do not use this trim in a one-function installation.
• Do not use a diverter tub spout.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
6.5 GPM