Adjusting The Drip Tray; Setting Up Your Dualbrew Single Serve Coffee Maker Using The Capsule Adaptor; Important - Bella 17244 Manual De Instrucciones Y Guía De Recetas

Adjusting the Drip Tray

1. Grasp the drip tray and cover from the base. (See Figure 2.)
2. Holding on to both pieces, slightly tilt upwards and slide out from the unit.
(See Figure 3.)
3. Using the tab on the back of the drip tray as your guide, again slightly tilt both pieces upwards
and glide the tabs into the upper slots on the Coffee Maker body. (See Figure 4.) Press down
on the drip tray with your hand to make sure it is firmly and properly attached before placing
the cup or mug on top.
Figure 2
Setting Up your Single Serve Coffee Maker Using the Capsule Adaptor
WARNING: Before brewing, it is recommended the water tank be filled at least to the MIN indicator line.
To avoid damage to your Coffee Maker, never operate your Single Serve Coffee Maker when the water tank is empty.
1. up and remove it from the base of the unit. (See Figure 1.)
2. Remove the lid and fill the water tank to the MAX indicator line with cold water.
NOTE: Never fill the water tank past the MAX indicator line and ensure water level is above the MIN
indicator line.
IMPORTANT: For optimal flavor, distilled or filtered water is preferred.
3. Put the lid back and put the water tank back into place. Place down firmly to make sure it is securely
in place.
4. Select the desired height for the drip tray, depending on the size of the cup, mug, or tumbler being
used
5. Place the empty cup, mug, or tumbler in position on the drip tray cover
6. Pull the adaptor compartment's front tab up to unlock and lift the lid.
7. Choose the capsule adaptor. Add the capsule of your choice into the adaptor. Press down on the
capsule until it is flush with the adaptor.You will hear a pierce as the needle penetrates the capsule.
8. With the handle facing front, place the capsule adaptor into the adaptor compartment.
Slide the adaptor handle in to the grooves at the front of the Coffee Maker.
9. Press the adaptor compartment's lid down firmly. An audible click can be heard as the lid is locked
firmly into position, and the top of the capsule will be punctured.
10. Plug the Coffee Maker into a 120V AC electrical wall outlet
11. To select the brew size press either the 6-oz, 10-oz or 15-oz button.
12. The light on the selected button size will begin to flash as the Coffee Maker begins heating the
water.
13. When the water has reached the optimum temperature, the light on the button will illuminate solid.
14. The pump will then activate and coffee will begin to stream through the nozzle.
15. To interrupt the brewing cycle at any time, press the same size button you had originally selected.
Then remove the plug from the wall outlet.
16. At the end of the cycle, the Coffee Maker and all indicator light will automatically turn OFF.
17. Allow unit to cool before removing the used capsule to discard.
18. Unplug the Coffee Maker when not in use.
17244 BELLA SIngle Serve with Water Tank IM R1.indd 7 17244 BELLA SIngle Serve with Water Tank IM R1.indd 7
Figure 3
Upper
Slots
Figure 4
7
2020-09-23 10:35 AM 2020-09-23 10:35 AM