Stanley SML Manual Del Usuario página 13

Horizontal Beam Accuracy
(See fi gure )
M
• Place laser tool as shown with horizontal, vertical, and
M
1
both left and right vertical laser beams ON. Mark point P
where the horizontal and left vertical laser beams cross.
• Rotate laser tool 90° and align front vertical laser beam
M
2
with point P . Mark point P
1
vertical laser beams cross.
• Rotate laser tool 90° and align right vertical laser beam
M
3
with point P . Mark point P
1
vertical laser beams cross.
• Measure the vertical distance D
M
4
and lowest point.
• Calculate the maximum offset distance and compare to D
• If D is not less than or equal to the calculated
2
maximum offset distance the tool must be returned to
your Stanley Distributor for calibration.
Maximum Offset Distance:
Maximum
Compare: (See fi gure
D
2
Example:
• D = 5 m, D = 0,65 mm
1 2
• 0,26 mm m x 5 m = 1,3 mm (maximum offset distance)
• 0,65 mm ≤ 1,3 mm (TRUE, tool is within calibration)
77-322
where the horizontal and front
2
where the horizontal and right
3
between the highest
2
= 0,26 mm m x D
m
1
= 0,0032 in ft x D
ft
1
)
M
4
≤ Maximum
Vertical Beam Accuracy
(See fi gure )
N
• Measure the height of a door jamb or reference point to
N
1
get distance D
1
Aim vertical beam towards door jamb or reference point.
Mark points P
• Move laser tool to opposite side of door jamb or
N
2
reference point and align the same vertical beam with
P and P .
2 3
• Measure the horizontal distances between P
N
3
vertical beam from the 2nd location.
• Calculate the maximum offset distance and compare to D
• If D is not less than or equal to the calculated
2
. maximum offset distance the tool must be returned to
2
your Stanley Distributor for calibration.
• Repeat the above steps to check the other beams.
Maximum
Example:
• D = 2 m, D
1
• 0,26 mm m x 2 m = 0,52 mm (maximum offset distance)
• 0,3 mm ≤ 0,52 mm (TRUE, tool is within calibration)
. Place laser tool as shown with laser ON.
1
, P , and P as shown.
1 2 3
Maximum Offset Distance:
= 0,26 mm m x D
= 0,0031 in ft x D
Compare: (See fi gure
D ≤ Maximum
2
= 0,3 mm
2
and the
1
.
2
m
1
ft
1
)
N
3
13