Toro 115–4190 Instrucciones De Instalación página 6

1. Cables
1. Plastic cable tie
2. Cables
3. Loosen the locknut and insert the cable ends
between the pulley. It is important to install the
cables as shown in Figure 11. This will ensure the
chute operates as shown in the Operation Section.
4. Install the cable into the slot and then push the
plastic retainer into the hole (Figure 11).
Figure 9
2. Plastic cable tie
Figure 10
3. Adhesive back mount
1. Handle
2. End of cable, install
between pulley
3. Inside cable
4. Outside cable
6
Figure 11
5. Chute gate
6. Install cable into slot and
then push plastic retainer
into hole
7. Loosen locknut