Bolt, (1/4 X 1-3/4 Inches); Bolt, (1/4 X 3/4 Inches) Locknut (1/4 Inch); Bracket; Handle Assembly - Toro 115–4190 Instrucciones De Instalación

4
Installing the Handle to a T-Bar
Gear Machine
Parts needed for this procedure:
1

Handle assembly

2

Bolt, (1/4 x 1-3/4 inches)

2 Bolt, (1/4 x 3/4 inches)
4
Locknut (1/4 inch)
1

Bracket

Procedure
1. Install the handle assembly to the angle bracket
with 2 bolts (1/4 x 3/4 inches) and 2 locknuts (1/4
inch)(Figure 5). Ensure to use the correct bracket.
1. Bolt (1/4 x 3/4 inches)
2. Bracket, ensure the
correct one shown is used
3. Handle assembly
2. Drill holes to mount the handle. Using the bracket as
a template, mark and drill 2 holes, 9/32 in diameter,
on the right side of the handle. Center the holes
on the tube and on either side of the reference bar
(Figure 4).
3. Install the handle assembly to the machine with
2 bolts (1/4 x 1-3/4 inches) and 2 locknuts (1/4
inch)(Figure 6).
Figure 5
4. Locknut (1/4 inch)
5. Short side
6. Long side
1. Bolt (1/4 x 1-3/4 inches)
2. Handle assembly
4
Figure 6
3. Drill two holes here (9/32in
dia.)
4. Locknut (1/4 inch)