Liquid Propane (Lp) Safety Information - LANDMANN 45027 Manual Del Usuario

Please review the below guidelines and safety information when using Liquid Propane (LP) gas.
General Information
• This grill is designed certified by ETL for use with
a standard 20 lb. LP gas cylinder.
• This grill CANNOT be converted to natural gas.
DO NOT attempt to convert this grill with a
different gas type.
Safety Information
• LP gas has an odor similar to natural gas.
• LP gas is heavier than air and leaking gas may
collect in low areas and resist dispersion.
• LP cylinders should not be dropped or handled
roughly.
• DO NOT use a damaged LP cylinder. A dented or
rusty LP cylinder or an LP cylinder with a damaged
valve may be hazardous and should be replaced
with a new cylinder immediately.
• ALWAYS close the cylinder valve after use.
• ALWAYS close the cylinder valve when
disconnecting the regulator.
• ALWAYS treat possible empty LP cylinders with
the same care as a full LP cylinder. There may still
be gas pressure inside a possible empty LP cylinder.
• NEVER store or transport an LP cylinder where the
temperature can reach 125°F.
• Keep LP cylinders away from children and pets.
• DO NOT store disconnected LP cylinders in a
building, garage or other enclosed areas.
• If the LP cylinder is kept in the grill between uses,
make sure to keep both the grill and the cylinder
in an outdoor area with good ventilation.
• ALWAYS test leak the LP cylinder connection to
the regulator when ever changing LP cylinders.

Liquid Propane (LP) Safety Information

Installation of LP cylinder
1. Make sure all burner controls are in the OFF
position.
2. Carefully position LP cylinder in the cavity
on the bottom panel.
3. To secure the LP cylinder in place, screw the
tank holding tray bolt through the bottom
section of the LP cylinder.
4. Attach the regulator to the cylinder by
carefully HAND TIGHTENING only.
5. NEVER use a wrench or other tool to tighten
this connection.
6. Observe all governing codes and ordinances.
Important
The United States LP gas appliance installation
must conform with local codes and ordinances.
In the absence of local codes, appliance installation
must conform with either the National Fuel Gas
Code, ANSI Z223.1/NFPA54, Natural Gas and
Propane Appliance code, CSA B149.1, or Propane
Storage and Handling Code, B149.2, as applicable.
For Canada, installation of this grill must comply
with local codes and/or Standard CSA B149.2
(Propane Storage and Handling Code).
5