Operate The Producer Iv; Power On The Producer Iv; Power Off The Producer Iv; Pause The Producer Iv - Rimage Producer P-IV 8200N Guia Del Usuario

Operate the Producer IV

This section provides you with the information needed to produce discs
using the Producer IV.

Power On the Producer IV

Before you begin:
The carousel must be installed before you power on the system. For more
information about installing the carousel, refer to the
section on page 10.
1. Press the power switch on
the rear of the autoloader.
The Producer IV powers on.
• If you have a Producer
6200N, 7200N, or
8200N, continue with
step 2.
• If you have a Producer
6200, the system is
powered on.
2. On the front of the autoloader, press the PC power button to power on
the embedded PC. The autoloader and embedded PC power on.
(6200N, 7200N, and 8200N Only)
2002543_A
Install the Carousel
Power Switch
PC Power Button
For more information visit

Power Off the Producer IV

1. Close all open applications.
• If you have a Producer 6200, continue to step 3.
• If you have a Producer 6200N, 7200N, or 8200N, continue to step 2.
2. Briefly press and release the PC power button. This shuts down the
software, Windows, and the embedded PC.
Caution: Do not press and hold the PC power button. If you press
n
and hold the PC power button, the embedded PC will not shut down
properly. This may cause data loss or corruption.
Note: It takes approximately 30 seconds for the system to power off.
3. Press the main power switch to power off the Producer IV.
Important! If you have a Producer 6200N, 7200N, or 8200N, do not
press the main power switch until the embedded PC is completely
powered off.

Pause the Producer IV

Pause the Producer IV to add discs to the autoloader.
1. Open the front door to pause operation.
2. Close the front door to resume operation.
rimage.com/support
9