Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Maintenance
Lubrication
Air tools require lubrication throughout the
lifetime of the tools. The air motor and bearing
uses compressed air to power the tool, due to
the moisture of the compressed air will rust
the air motor and other parts in side of the
tools, therefore lubrication is required daily.
Failure to lubricate the air tool properly will
dramatically shorten the life of the tool
and will void the warranty.
CAUTION
This air tool requires lubrication BEFORE initial
use, also before and after each additional use.
To lubricate the air tool manually:
1.Remove any attachment on the drive of air
tools, such as: sockets, chisels and etc.
2.Disconnect the tool from the air supply
source, place the air inlet faces up.
3.Depress the trigger or throttle and place
about 1 teaspoon (5cc.) of air tool oil into
the air inlet. (Depressing the trigger or
throttle will help circulating oil in themotor.)
NOTE:
Use SAE #10 weight oil if air tool oil is not available.
WARNING
Keep out of the reach of children. If taken
internally, do not induce vomiting, call
a doctor immediately.
4.Connect the tool to air source, cover the
exhaust end with a towel and run for about
20 to 30 seconds.
WARNING
Any excess oil in the motor is immediately
expelled from the exhaust port. Always direct
exhaust port away from people or objects.
Storage
The air tool must be lubricated before storing.
Follow the "Lubrication" instruction with
exception of step 4.
WARNING
NOTE:
Danger alerts you to a hazard that WILL result in death
or serious injury.
Warning alerts you to a hazard that COULD result in
death or serious injury.
Caution alerts you to a hazard that MAY result in
minor injury.
Tabla de contenido
