Scott Safety Promask Instrucciones Para El Uso página 23


Unscrew the screws (Torx 20), loosen the visor frames, and remove the visor (Fig. A)
 Place a new visor in the faceblank (with the marking "UP" on the visor showing upwards). Align
the check marks of the visor and faceblank with each other (Fig. B).

Position the visor frames and tighten both screws (Fig. C).

Carry out the leak-tightness test (point 5.1).
5.3 Replacing the exhalation valve disc

Pull out the valve cover (Fig. D).

Separate the disc (yellow) from the valve body (grip on the edge of the disc) (Fig. E).

Fit new disc. Press lightly on the tip of the disc to secure a good fit (Fig. F).
5.4 Replacing the inhalation valve discs

Remove the rubber valve seat for instance by pushing it with a finger from the inside of the mask
(Fig. G).

Place a new disc in the seat (pass the tail through the central hole) (Fig. H).

Put the valve seat back to the bottom of the valve body (Fig. J). Do not press too tight (the disc
comes immobilised) because the disc must be free to move.

The valve discs of the inner mask are replaced similarly (Fig. X). Make sure that the rubber edge
of the inner mask comes in the valve seat groove.
5.5 Replacing the speech diaphragm

Remove the inner mask from around the speech diaphragm (Fig. K).

Press the clip to remove the speech diaphragm (Fig. L–M). To make assembly easier, moisten
the O-ring with water. Press the speech diaphragm into place.

Insert inner mask into place.
5.6 Replacing the harness buckle

Press the buckle downwards (Fig. N).

Hold the buckle and twist the rubber endpiece through the gap to the other end of the buckle
(Fig. O–P) (the buckle rotates 180).

Remove the buckle (Fig. Q).

Assemble in reverse order.
5.7 Replacing the inner mask

Remove first the inhalation valve seat by pushing it with a finger from the inside of the mask
(Fig. G).

Gently pry open the hole on the fastening ring of the inner mask, using a screwdriver (via the inh.
valve body opening) until the fastening ring comes off (Fig. R).

Remove the inner mask (Fig. S).

When assembling, insert the notch of the fastening ring into the tip of the exhalation valve (Fig.
T) and press the inner mask into place.
5.8 Replacing the speech channel cover
 Unscrew screws (Torx) to remove the cover (Fig. U-V).
 Position replacement cover, check that the cover comes over the front rim of speech channel
body.
 Secure cover with screws.
23
23