BGS technic 3291 Guia De Inicio Rapido página 4

Amoladora angular neumática
Ocultar thumbs Ver también para 3291:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

SPECIFICATIONS
Grinding disc holder: 30-50-75 mm
Mounting thread: M6 x 1
Speed max.: 15,000 U/min
Stroke: 3 mm
Operating pressure: 6.3 Bar (90 PSI)
Air consumption: 70.8 L/min
Air inlet: 1/4"
Sound pressure level LpA: 92.23 dB(A)
Sound power level LwA: 103.23 dB(A)
Vibration level: ahd=3.4 m/s² / K=0.83 m/s²
Air outlet: near air connector
Length: 182 mm
Weight: 710 g
WARNING!
Read and understand and follow all instructions and warnings before operating this tool.
Failure to do so may result in personal injury and/or property damage and will void warranty.
SAFETY INFORMATIONS
Use proper air pressure and CFM rating listed for this tool.
Be sure air is in OFF position when connecting tool to air supply.
Always wear approved eye protection when using tools. If raising dust, wear a suitable mask.
Use only accessories that are designed for use with air tools.
Be sure to disconnect tool from air supply before changing accessories, performing service on
tool, and when not in use.
As with any tool, use common sense when operating. Do not wear loose clothing or jewellery
that could become caught by moving parts, causing injury. Operate tool a safe distance from
yourself and others in the work area.
Follow air source manufacturer's directions for connection of regulators, filters, and other
accessories to air source.
Keep children and other unauthorized persons away from the work area.
Do not allow children to play with the tool or its packaging.
AIR SOURCE
Clean air of correct air pressure is recommended for the power supply for this tool. A maximum of 90
PSI at the tool is recommended for most air tools of this class. Check specifications section for
recommended pressure. (Depending on length of air hose and other circumstances, air pressure at
compressor may need to be increased to 100 PSI to ensure 90 PSI at the tool.) Water in the air hose
and compressor tank contributes to reduced performance and damage of the air tool. Drain the air
tank and filters before each use and as necessary to keep the air supply dry. Hose length over 25"
causes loss in line pressure. Increase hose ID or increase compressor pressure to compensate
pressure
loss.
Use an in-line pressure regulator with gauge if air inlet pressure is critical.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Air Angle Sander
Tel.: 02196 720480
Fax.: 02196 7204820
BGS 3291
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
loading

Tabla de contenido