Maintenance And Cleaning; Wear Parts; Storage/Over-Wintering - Oase SwimSkim CWS Instrucciones De Uso

- GB -
Pos: 98 /Alle Produkte/Überschriften/H1 Reinigung und Wartung @ 7\mod_1196625212761_121.doc @ 41469 @
6.

Maintenance and cleaning

Pos: 99 /Filter/SwimSkim CWS/WAR Reinigung und Wartung SwimSkim CWS @ 8\mod_1221649546672_121.doc @ 52939 @
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures: Disconnect the power plugs of all the units in the water prior to reaching into the
water and commencing work.
Regular cleaning (Figure F)
1. Remove the filter basket (8).
You can leave the SwimSkim CWS in the water by hooking in a sufficiently long pole at the
−
handle (4) and removing the filter basket (8).
2. Clean the filter basket (8) with clean water and a soft brush. If a foam filter (7) was used before,
clean same additionally with clean water.
3. Set the filter basket (8) in the SwimSkim CWS again.
Complete cleaning (Figure F-I)
1. Remove the unit from the water.
2. Remove filter basket (8) and, if necessary, the foam filter (7).
3. Undo three screws (17) from the container and remove the container (16).
4. Disconnect the air hose (24) connected to the intake socket (23) from the air controller (25). During
cleaning, the air hose (24) remains in the intake socket (23).
5. Unscrew the flow-out nozzle (3).
6. Remove the pump (18) from the pump chamber (1)
7. Disassemble the pump (18):
− Pull off the intake socket (23).
Unscrew four screws (19) from the rear of the pump.
−
Remove pump housing (22), O-ring (21) and the impeller (20).
−
8. Clean all components using clean water and a soft brush. If a foam filter (7) was used, clean same
with clean water.
9. Reassemble the unit in the reverse order.
Pos: 100 /Filter/SwimSkim CWS/HINW_Positon_Luftschlauch_SwimSkim_CWS @ 9\mod_1231836103015_121.doc @ 59333 @
Check the position of the air hose (24) in the intake socket (23).
Insert the air hose up to the mark (26) to ensure that the water aeration functions correctly.
Pos: 101 /Alle Produkte/Dummy_module/Abstand 18 pt @ 6\mod_1196355593257_0.doc @ 41089 @
Pos: 102 /Alle Produkte/Überschriften/H1 Verschleißteile @ 8\mod_1223247075102_121.doc @ 53883 @
7.

Wear parts

Pos: 103 /Filter/SwimSkim CWS/Verschleißteile SwimSkim CWS @ 8\mod_1223247486058_121.doc @ 53937 @
Impeller (20) and foam filters (7) are wearing parts and are, therefore, not covered by our warranty.
Pos: 104 /Alle Produkte/Dummy_module/Abstand 18 pt @ 6\mod_1196355593257_0.doc @ 41089 @
Pos: 105 /Alle Produkte/Überschriften/H1 Lagern / Überwintern @ 7\mod_1196625251745_121.doc @ 41495 @
8.

Storage/Over-wintering

Pos: 106 /Filter/SwimSkim CWS/Lagern und Überwinter SwimSkim CWS @ 8\mod_1221649614501_121.doc @ 52965 @
Remove the unit at temperatures below zero degrees centigrade. Clean the unit thoroughly, check for
damage and store immersed in a frost-free environment. Ensure that the power plug is not flooded.
Pos: 107 /Alle Produkte/Dummy_module/===== Seitenwechsel ===== @ 0\mod_1125648978015_0.doc @ 1631 @
12