Assembling The Guide Bar And Saw Chain - Powerworks 2000213 Manual De Utilización

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
21. Chain drive links
22. Cutter
23. Felling direction
24. Danger zone
25. Escape route
26. Direction of fall
27. Notch
28. Felling back cut
29. Hinge
30. Limb cut
31. Keep work off ground leave support limbs
until log is cut
32. Log supported along the entire length
33. Cut from top (over buck) avoid cutting
earth
34. Log supported one end
35. Under buck
36. Over buck
37. Log supported both ends
38. Bucking a log
39. Stand on uphill side when cutting because
log may roll
ASSEMBLY
This chain saw requires no assembly, but user
should know how to assemble the guide bar
and saw chain. Check the chain tensioning
and add oil as described later in this manual
before each operation.
ASSEMBLING THE GUIDE BAR AND SAW
CHAIN
See figure 2 - 7
Make sure remove the battery pack from the
unit. Wear protective gloves.
Unscrew the sprocket cover tighten knob
„
and remove the sprocket cover.
English (original instructions)
The saw chain should face in the direction
„
of chain rotation. If they face backwards,
turn the loop over.
Place the chain drive links into the bar
„
groove.
Position the chain so there is a loop at the
„
back of the bar.
Hold the chain in position on the bar and
„
place the loop around the sprocket and
make sure it is correctly mounted. Make
sure the bar hole fits well with bolt for saw
chain tension.
Replace the sprocket cover, turn the
„
chain tension adjust knob clockwise until
the saw chain is properly tensioned. The
guide bar must then be pushed upwards,
check chain tension again, do not tension
the chain too tight.
After the chain is well-tensioned, tighten
„
the knob again.
NOTE: The saw chain is properly tensioned if,
in the middle of the guide bar, it can be lifted
3mm to 4mm from the edge of the guide bar.
Start the saw again with a new saw chain,
allowing it to run-in for 2~3 minutes.
After the run-in time, check the chain tension
and retighten the chain if necessary.
OPERATION
For complete
refer to the Operator's Manuals for your
Greenworks Tools
charger models.
NOTE: To avoid serious personal injury,
always remove the battery pack and keep
hands clear of the lock-out button when
carrying or transporting the tool.
BEFORE EACH USE CHECK THE CHAIN
TENSION
2
WARNING
charging instructions,
battery pack and