Tabla de contenido
Connecting a video recorder
To obtain optimum picture quality, use a SCART cable. However, you can also connect a video recorder to the
television using the aerial socket.
If you connect a video recorder only via the aerial socket (without using the SCART socket), switch it on and play
a tape.
Then search for the video recorder's relevant channel (refer to the relevant section).
If you connect a video recorder via the aerial socket, you should assign channel 99 to it in order to improve the
picture quality when tapes are being played and in pause mode. However, we recommend you connect your video
recorder via the SCART socket, as it provides better picture and sound quality.
Connecting a Computer
Note:
The display native resolution is 1280 x 720. If the signal resolution exceeds the native resolution, it may not
1.
be possible to show fine detail with sufficient clarity.
An adapter is required to use the PC cable (D-sub 15P) to connect a Macintosh computer to the set.
2.
Some PC models cannot be connected to the set.
3.
There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminals.
4.
Do not set the horizontal and vertical scanning frequencies for PC signals, which are above or below the
5.
specified frequency range.
For more information about external device connections, see the manuals of your external devices.
Method A :
Connect the VGA signal terminal on the back side of the LCD TV to the output of PC
equipment through min D-sub 15 pin cable.
Connect the stereo sound input jack (VGA AUDIO), on the back of the LCD TV, to
the audio output terminal on the computer.
To display images from the connected computer, select VGA using AV button on the remote
control
Method B : (Depending on model) Requires the use of a HDMI/DVI cable
Connect one end of the cable to the HDMI connector at the back of the LCD TV and
the other end to the DVI Out of the PC.
Connect the sockets DVI Audio In situated near the socket HDMI to the Audio Out
sockets of the PC.
To display images from the connected computer, select HDMI/DVI using AV button on
the remote control
Select PC at the DVI input line of Préférences menu (see page 18)
23
Tabla de contenido
