Safety Warnings - Uline H-3535 Manual De Instrucciones

NOTE: Read these warnings to prevent injuries
to yourself and those around you.
• Never use oxygen, combustible gases, CO
or high pressure gas tanks as power sources. The
stapler may explode and cause serious injury.
• Use only dry, clean pressure-regulated compressed
air to drive the stapler.
• Eye protection must be worn by the operator and
others in the work area.
• Always use personal protection equipment as
required, such as ear protection, hard hats, etc.
• Never use a defective stapler. Ensure the trigger
operates properly and all screws and nuts are
secured tightly at all times.
• Do not modify the stapler.
• Always disconnect the stapler from the air supply
and empty the magazine when taking a break
or ending work, when servicing the stapler or
eliminating malfunctions.
• Never leave a loaded stapler unattended.
• Always assume that the stapler is loaded. No
horseplay! Respect the stapler as a working tool.
• Never point the stapler at yourself or at anyone else,
whether it contains staples or not. Always remove
your finger from the trigger when not driving staples.
• Always disconnect the stapler from the air supply,
empty the magazine and read the safety warnings
before starting maintenance.
• Check daily that all safety devices function properly,
especially that the trigger moves freely and that all
screws and nuts are securely tightened.
PAGE 3 OF 12

SAFETY WARNINGS

• Connect the stapler to the compressed air line
before loading staples. Maximum air pressure is
7 bar.
, steam
2
• Ensure that the air hose has the right dimension
to avoid pressure drops which might cause
malfunctioning. Minimum 1/4".
• The stapler and the hose must have a coupling
which automatically bleeds all air pressure from the
stapler when it is disconnected.
• Avoid personal injury. Never hold your hand or
another part of your body under the stapler.
• Do not load the stapler with the trigger depressed.
• Use only Josef Kihlberg JK590 staples: Item # S-18712,
S-18713 and S-18714.
• Always place yourself in a firmly balanced position
when using or handling the stapler.
• Stapling and nailing tools that are
marked with an inverted equilateral
triangle may only be used in conjunction
with an operating safety support.
• Stapling and nailing tools that are
marked with this symbol must not be
used when standing on a stepladder
or scaffolding.
MAINTENANCE
• This stapler does not require any special servicing.
It only needs regular cleaning with a non-corrosive
cleaning agent. Do not remove any parts for
cleaning purposes!
• Check that the stapler is properly lubricated.
The stapler must be lubricated by an oil mist.
A silicon-based grease is recommended.
0421 IH-3535