Charging The Battery - Ratio 7993 X 305 Manual De Instrucciones

INSTALLATION
The machine is ready for use on delivery.
Package Contents:
- 1 Cordless screwdriver
- 4 pcs. 25mm bits, and 6 pcs. precision bits,
1 pcs. adapter for precision bits.
- USB charging cable.
Check the power tool, parts and accessories
for any. transport damage. Be sure to charge
the battery completely before use. Use only
the machine with bits that are suitable for the
purpose and which are not damaged.
USE Purpose: The screwdriver is intended
for screwing / loosening smaller screws.
Incorrect use: Any use of the machine for
tasks other than those mentioned in the
"intended use" section is considered to be
incorrect use of the machine. The product is
not intended for professional use.
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read
the instruction book carefully.
Intended Use

1.CHARGING THE BATTERY:

1. The USB cable (charge cable) can be
connected to a suitable adapter that delivers
5V and <2A or it can be connected to a
computer's USB port. The charging process
starts as soon as the charging cable is
connected.
2. Charging LED lights up red to indicate that
the battery is charging.
3. When charging LED lights green, charging
is complete.
CHARGING INDICATOR
Light
red on
green on
Warning: When battery charge runs out
after continuous use or exposure to direct
sunlight or heat, allow time for the tool to
cool down before re-charging to achieve
Status
Charging
Fully Charged
the full charge.
Important! The handle may get a little hot
during charging. This is normal. Never leave
the battery fully discharged. This will make it
a defect. Early charging of the battery helps
to serve you well for a long time. You must
recharge the battery when you notice that
the screwdriver's power drops. Use the ON /
OFF switch and direction selector. The switch
(2) on this machine acts as both switch on /
off switch and switch for rotational direction.
Pressing on the front of the connector
(marked with) rotates the machine clockwise
(tighten screw and bolts) and pressed on
the lower part of the connector (marked with
2) rotates the machine counterclockwise
(loosen screw and bolts). When the plug
is released, the engine stops. Make sure
the machine is stopped completely before
selecting the reverse direction of rotation.
Screwing: Fit a bit into the bit holder (5).
Use a suitable screw designed for the work
being carried out. Be sure to use a bit that
fits the screw.
2) Electrical safety.
a) The power tool's electrical outlet must
fit the socket. Never modify a plug in any
way. Never use adapter connectors with
(grounded) power tools. Plug-in connectors
in the original version and suitable sockets
reduce the risk of electric shock.
b) Avoid body contact with grounded
surfaces such as pipes, elements, stoves
and refrigerators. The risk of electric shock
increases if you are grounded.
c) Do not expose the power tool to rain or
moisture. Water that penetrates the power
tool increases the risk of electric shock.
d) Do not use the cable incorrectly. Never
use the cable to carry or pull the power tool.
Never pull the cable to pull out the plug.
Keep the cord away from heat, oils, sharp
edges or moving parts of the machine.
Damaged or truncated power cables
increase the risk of electric shock.
e) Use an extension cable designed for
outdoor use when using the power tool
outdoors. The risk of electric shock reduces
when using cable designed for outdoor use.
35