English; Removing The Rechargeable Battery - Philips FC6162 Manual Del Usuario

English

8

Removing the rechargeable battery

Only remove the rechargeable battery when you discard the product. Before you
remove the battery, make sure that the product is disconnected from the wall socket
and that the battery is completely empty.
Take any necessary safety precautions when you handle tools to open the product and
when you dispose of the rechargeable battery.
To remove the rechargeable battery, follow the instructions below.
1 Let the appliance run until it stops.
2 Remove the dust container and the cyclone from the handheld vacuum cleaner (Fig. 5).
3 Undo two screws on the inside of the handheld vacuum cleaner (Fig. 6).
4 Turn the handheld vacuum cleaner and remove four screws on the other side (Fig. 7).
5 Remove the back panel from the handheld vacuum cleaner (Fig. 8).
6 Insert a screwdriver and push it down to remove the panel on the left side of the appliance (Fig. 9).
7 Remove two screws from the bottom (Fig. 10).
8 Remove four screws on the left side of the appliance (Fig. 11).
9 Remove the left housing part (Fig. 12).
10 Take out the rechargeable battery and cut the wires connected to it one by one (Fig. 13).
Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, visit www.philips.com/support for a list
of frequently asked questions or contact the Consumer Care Center in your country.
Problem
The appliance does not
work when I push the
button.
The appliance has a lower
suction power than usual.
Possible cause
The battery light flashes fast
because the batteries are
low.
You cannot use the
appliance because the
appliance is still charging.
You have to press two
buttons.
The filter and the cyclone are
dirty.
You have not connected the
dust bucket, the dust
separator and the cyclone
properly. Incorrect assembly
of these parts causes air
leakage, which leads to loss
of suction power.
Solution
To charge the batteries, insert the small
plug into the socket on the appliance
and insert the adapter into a wall socket.
You have to remove the small plug from
the socket on the appliance before you
can switch on the appliance.
First press the on/off button to switch
on the appliance. Then press the MAX
button to get maximum suction power.
Clean the filter and the cyclone.
Connect the dust bucket, the dust
separator and the cyclone properly.