Milwaukee SG 6-125 QX Manual De Instrucciones página 7

WARNING!
Because the wires on wire wheel
brushes are directed towards the opera-
tor, a guard must be used to protect the
operator when fatigued wires break.
WARNING!
Never exceed Maximum Safe Operating
Speed of brush. Do not use a damaged
brush or one which is functioning
improperly (throwing wires, out-of-bal-
ance, etc.). These conditions increase
the possibility of further brush failure
and possible injury. Discard and re-
place damaged brushes immediately.
Test wire brush for balance and loose or
damaged wires by running tool at no load
speed for at least 30 seconds before ap-
plying it to your work. During this time, no
one should stand in front of or in line with it.
When applying brush to work, avoid using
too much pressure. This causes over-bend-
ing of wires and heat buildup resulting in
premature wire breakage, rapid dulling and
reduced brush life. Instead of using more
pressure, try a wire brush with more ag-
gressive cutting action (increased wire
size, decreased wire length or different
brush type, i.e. knot type instead of crimped
wire type).
WARNING!
Unplug tool before removing or attach-
ing accessories. Maximum Safe Operat-
ing Speed of wire wheel brush, sanding
disc, backing pad and grinding wheel
must be greater than no load RPM of tool.
Guards must be used with grinding
wheels and wire wheels. Only use spe-
cifically recommended accessories.
Others may be hazardous.
WARNING!
To reduce the risk of injury, use only
identical replacement parts.
5223-50
Operation
WARNING!
To reduce the risk of injury, ALWAYS
wear safety goggles or glasses with
side shields.
Starting and Stopping
1. To start the tool, pull the trigger.
2. To stop the tool, release the trigger.
Using the Lock-On Mechanism
The lock-on holds the trigger in the ON posi-
tion for continuous full speed use.
1. To lock the trigger, hold the lock on but-
ton in while pulling the trigger, then re-
lease the trigger.
2. To unlock the trigger, pull the trigger and
release. The lock on button will pop out.
Grinding
1. Hold handle and spindle housing firmly.
2. Pull trigger.
3. Allow tool to reach full speed.
4. Apply grinder to the workpiece.
Maintenance
Cleaning
WARNING!
To reduce the risk of injury, electric
shock and damage to the tool, never
immerse your tool in liquid or allow a
liquid to flow inside the tool.
Clean dust and debris from vents. Keep the
tool handles clean, dry and free of oil or
grease. Use only mild soap and a damp
cloth to clean your tool since certain clean-
ing agents and solvents are harmful to plas-
tics and other insulated parts.
Repairs
Use only identical MILWAUKEE replace-
ments parts. Always take the tool to an
authorized MILWAUKEE service center for
repairs and maintenance.
5 English