General Instructions; Safety Instructions - Denios DT250 Guia De Inicio Rapido

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

English

1. General Instructions

No modifications or alterations can be made to the product without authorisation from the manufacturer, in the
event of this, the guarantee will be invalidated.
National standards and safety regulations must be observed.

2. Safety instructions

Before the product is used, it is to be checked for correct functioning. Should any defects appear, it must not be
used!
The German regulations BGV D8 (hoisting, lifting and winching equipment and BGV D27 (industrial
trucks) are to be observed!
Only use for the intended purpose!
The load must not be left in raised position.
The drums must only be raised slightly for when being transported.
The bearing capacity given must not be exceeded!
Safety instructions for ex-model
Chemical and mechanical influences as well as the accumulation of obstructive substances can alter electrical
conductivity to such an extent that the permitted levels laid out in standards are exceeded. Dust, dirt, paint, acids,
leaches, overloading and impact loads, in particular, may impede or completely prevent electrical or electrostatic
energy from being relayed to the ground. For this reason, you must keep the device completely clean, especially
its wheels and castors, and you must not apply an extra layer of paint.
Because of the abundance of influences unknown to us in the use of our products our guarantee with respect to
the electrical conductivity relates exclusively to the compliance with the permitted values of the wheels in new
condition on delivery laid down in the standards.
The constant observation of technical safety regulations such as e.g. compliance with the values with respect to
electrical conductivity in use is exclusively in the area of responsibility of the user.
Only use DENIOS replacement parts when replacing components. Replacing with unsuitable parts will mean the
device is no longer ATEX-compatible.
3. Use and intended purpose
With the DT drum transporters and the RT drum lifters 200-litre steel drums according to EN 210 can be lifted and
transported.
Because of its special chassis the RT drum transporter is suitable for the fitting of DENIOS sumps or
commercially-available Euro pallets.
The operational temperature range is from -10°C to 40°C.
4. Assembly
Connect the fork feet (2) with the chassis (12). Use the bolt provided (11).
Fasten the hydraulics/cylinder assembly (3) with the screw (4) on the chassis (12).
Place the tow handle (5) in the pump seating of the hydraulics assembly (3) and fasten this with the screw (4).
Fasstransporter DT250 /Fasslifter RT250
164380 / 164387, 180867, 180868
Seite 7 von 18 Seiten
Ausgabe 05/2010
Tabla de contenido
loading

Este manual también es adecuado para:

Rt250164380164387180867180868

Tabla de contenido