Bosch ART EASYTRIM Accu 23 Manual Original página 16

OBJ_BUCH-2333-001.book Page 16 Tuesday, November 18, 2014 4:33 PM
16 | English
The charging procedure is not ended automatically. There-
fore, disconnect the battery charger from the mains supply af-
ter the battery has been charged and remove the battery. A
temperature increase of the battery indicates that the battery
is fully charged.
Note: The charging procedure is only possible when the bat-
tery temperature is within the allowable charging tempera-
ture range, see section "Technical Data".
Troubleshooting
d.c.
Problem
Blade guard can not be mounted
over cutting disc
Trimmer fails to operate
Trimmer runs intermittently
Excessive vibrations/noise
Cutting time per battery charge too
low
Blade will not move
Machine does not cut
Continuous lighting of the battery
charge indicator
No charging procedure possible
Battery charge indicator does not
light up
F 016 L81 227 | (18.11.14)
Charging Advice
With continuous or several repetitive charging cycles without
interruption, the charger can warm up. This is not meaningful
and does not indicate a technical defect of the battery charg-
er.
A battery that is new or that has not been used for a longer pe-
riod will not achieve its full capacity until after approx. 5
charging and discharging cycles. Leave such a battery in the
battery charger until it has warmed up considerably.
A significantly reduced working period after charging indi-
cates that the battery is used and must be replaced.
Possible Cause
Incorrect assembly
Battery discharged
Battery too hot/cold
Internal wiring of machine damaged
On/Off switch defective
Machine defective
Blade broken
Battery has not been used for long pe-
riod or only for short terms
Grass too high
Battery dead or defective
Battery discharged
Machine defective
Blade broken
Battery not fully charged
Grass entangled around cutting disc
Battery not (properly) inserted
Battery contacts contaminated
Battery pack defective
Mains plug of battery charger not
plugged in (properly)
Battery not (properly) inserted
Socket outlet, mains cable or battery
charger defective
Corrective Action
Remove cutting disc and mount blade guard
again; also see "Mounting"
Recharge battery; also see "Battery Charging"
Allow to cool/warm
Contact Service Agent
Contact Service Agent
Contact Service Agent
Replace the blade
Fully charge battery; also see "Battery Charg-
ing"
Cut in stages
Replace the battery
Recharge battery; also see "Battery Charging"
Contact Service Agent
Replace the blade
Recharge battery; also see "Battery Charging"
Remove grass
Properly insert battery into battery charger
Clean the battery contacts (e.g. by inserting
and removing the battery several times) or re-
place the battery
Replace the battery
Insert mains plug (fully) into the socket outlet
Properly insert battery into battery charger
Check the mains voltage; have the battery
charger checked by an authorised after-sales
service agent for Bosch power tools
Bosch Power Tools