Light Indicator
4.
Right earcup indicator
Green and blinks slowly: ready to connect a device.
Green and blinks rapidly: attempts to connect to a Creative
ShareMe headset.
Blue and blinks slowly: connected to a paired device.
Blue and blinks rapidly: in pairing mode and is ready to pair
with a new device.
Blue and green blinks simultaneously: in an active Creative
ShareMe connection.
Red and fl ashes once: powering off the headset.
Red and blinks slowly: low battery level, charge the headset
soonest.
5.
Left earcup indicator
Red: charging headset. This goes off when headset is fully
charged.
Connector / Port
6.
Use the supplied USB cable for charging the headset via a
Micro-USB charging
laptop or computer.
connector
7.
Use the supplied audio cable for a wired connection to non-
Audio Input connector
wireless devices or when battery power runs out. Connect the
smaller 2.5mm diameter plug to the headset (align the triangular-
shaped connector properly) and the larger 3.5mm diameter plug
to your audio device.
8.
Noise suppression microphone for crystal clear communications.
Invisible Microphone
9.
Tap your NFC-enabled mobile devices here to establish
NFC (Near Field
Bluetooth pairing and connection. Tap again to end connection.
Communication) pad
Function
Function
Technical Specifi cations:
•
Driver: 34mm Neodymium magnet
•
Frequency Response: 18Hz ~ 22kHz
•
Impedance: 32ohms
•
Wireless Technology: Bluetooth v3.0
•
Bluetooth Profi les: A2DP, AVRCP, HSP, HFP (HD Voice ready)
•
Audio Codec: aptX, AAC, FastStream*, mSBC, SBC
•
Content Protection: SCMS-T
•
Operating Frequency: 2402 ~ 2480 MHz
•
Operating Range: Up to 10m / 33ft
•
Power Supply: Rechargeable Lithium Ion battery, 3.7V, 430mAh
•
Charge via USB: 5VDC, 500mA
•
Charge Time / Play Time / Talk Time: 2 hours / 12 hours / 14 hours
•
Net Weight: 150g / 5.3oz
* FastStream allows low latency wireless bi-directional audio streaming and voice communication with
Creative BT-W1 Bluetooth USB transceiver
HD Voice requires supported smartphones and mobile networks.