Uline H-5839 Manual De Instrucciones página 4

TOOL REQUIRED
M8 Flange
Nut x 2
M8 x 16 mm
Bolt x 2
M6 x 10 mm Cap Nut
Screw x 9 x 9
1. Line up holes on the
bracket of wheel
assembly with the
corresponding
holes on base,
then insert 16 mm
bolts through holes.
Hand tighten with
flange nuts. Be sure
the wheel assembly
is parallel to the
base. (See Figure 1)
NOTE: To improve stability, the bucket (in base)
can be filled with sand (not included).
2. Attach cylinder
housing loosely
to base with
M5 x 8 mm screws.
(See Figure 2)
PAGE 4 OF 31
Phillips Screwdriver
(not included)
M5 x 8 mm
Screw x 4
M6 x 10 mm
Bolt x 4
Wing Nut Stainless
x 3 Steel Bolt
x 4
(May be attached
to head assembly)
Figure 1
Fill sand
Figure 2
PARTS
Small Flat
Washer
x 4
Wrench
x 1
ASSEMBLY
3. Open the
preassembled door
on cylinder housing
and place post
through the hole on
the top.
(See Figure 3) (See Figure 3)
4. Secure post to
cylinder housing
using the reinforced
ring, M6 x 10 mm
bolts and four small
flat washers. Fasten
and cover with the
deck ring.
(See Figure 4)
Large Washer
x 9
Reflector
Spacer
x 3
Reinforced Deck Ring x 1
Ring x 1
Figure 3
Figure 4
Medium Flat
Washer x 9
0821 IH-5839