Tabla de contenido
Idiomas disponibles
Idiomas disponibles
384621-01/DW866
1/8/02
2:27 PM
Minimum Gage for Cord Sets
Volts
Total Length of Cord in Feet
120V
0-25
240V
0-50
Ampere Rating
More
Not more
Than
Than
0
-
6
18
6
-
10
18
10
-
12
16
12
-
16
14
Grounding
This tool should be grounded while in use to protect the operator from
electric shock. The tool is equipped with an approved three-
conductor cord and three-prong grounding type plug to fit the proper
grounding type receptacle. The green (or green and yellow)
conductor in the cord is the grounding wire. Never connect the green
(or green and yellow wire to a live terminal.
If your unit is intended for use on less than 150 volts, it has a plug
similar to that shown in Figure A. An adapter, Figures B and C, is
available for connecting Figure A plugs to two-prong receptacles.
The green-colored rigid ear, lug, etc., must be connected to a
permanent ground such as a properly grounded outlet box.
Whenever the adapter is used, it must be held in place by a metal
screw.
ADAPTER SHOWN IN FIGURES B and C IS NOT FOR USE IN
CANADA.
A
GROUNDED
B
OUTLET
BOX
GROUNDING PIN
Page 1
26-50
51-100
101-150
51-100
101-200 201-300
AWG
16
16
14
16
14
12
16
14
12
12
Not Recommended
C
D
GROUNDING
MEANS
ADAPTER
GROUNDING PIN
PERSONAL SAFETY
• Stay alert, watch what you are doing and use common sense
when operating a power tool. Do not use tool while tired or
under the influence of drugs, alcohol, or medication. A moment
of inattention while operating power tools may result in serious
personal injury,
• Dress properly. Do not wear loose clothing or jewelry. Contain
long hair. Keep your hair, clothing, and gloves away from
moving parts. Loose clothing, jewelry, or long hair can be caught
in moving parts.
• Avoid accidental starting. Be sure switch is off before
plugging in. Carrying tools with your finger on the switch or
plugging in tools that have the switch on invites accidents.
• Remove adjusting keys or wrenches before turning the tool
on. A wrench or key that is left attached to a rotating part of the tool
may result in personal injury.
• Do not overreach. Keep proper footing and balance at all
times. Proper footing and balance enables better control of the tool
in unexpected situations.
• Use safety equipment. Always wear eye protection. Dust mask,
non-skid safety shoes, hard hat, or hearing protection must be used
for appropriate conditions.
• The label on your tool may include the following symbols.
V
................................volts
A
................................amperes
Hz ................................hertz
W ....................................watts
min..................................minutes
....................................alternating current
................................direct current
n o....................................no load speed
....................................Class II Construction
1
Tabla de contenido
