Premier WH-4496 Manual De Instrucciones página 18

! Water Entering: After fixing all the pipes, then make the cold and heat water-blending valve rotate to
the high temperature sector according to the clockwise direction. And reopen the cold water pipe's
water entering valve. At this time, the electric water heater's tank will start to enter the water. Waiting
that the shower sector of the water exiting mouth is in normal condition, which indicates that the tank
has fully filled with water. Cautions: During the electric water heater is in the normal operating
procedures, the water-entering valve of the cold water pipe's mouth-entering sector must be in the
open condition from the beginning to the end. At this time, the water-entering valve can still make
the functions of regulating the water-existing mouth section's flowing strength and weakness.
However, the cold and hot mixed water valve can only regulate the water temperatures an make the
function of closing the water exiting.
! Putting through the power: After confirming the tank to be fully filled the water, you can make the
power source's plug insert into the outlet and put through the power sources.
! Hot water operations: After the electric water heater normally works and heats for a long period of
time, you can use the hot water in the tank, you need to make the cold and hot mixed valve rotate
with the clockwise direction slowly from the low temperature to the high temperatures in the closed
condition. And adjust it to your proper temperature. At that time, the shower mouth can come out the
hot water. After finishing the uses, you can turn it to the closed section by the anti-clockwise
direction and shut off the mixed water valve.
Cautions: When adjusting the water temperature of the water-exiting mouth, you don't make the
shower directly to the human body; you should test the water temperature first to burning to
damages.
! Overheating Protections: Under the condition of putting through the power, but the heating pipe
won't heat from the beginning from the end .At this time ,it may appear the over heat protections
(that is to make functions by the double-positional temperature-limiting protection switch).
! Automatically balance the temperatures: When the water temperature in the tank reaches the set
one, it will automatically cut off the power and halt heating. Meanwhile, the heating indicator will put
out. The electric water heater will be in the temperature-maintaining condition. When the water
temperature in the tank reduces to a certain one, it will automatically begin to heat. After reaching
the temperature, it will automatically cut off the power and be in the temperature-keeping condition.
It will circulate to automatically work like these.
OPERATING INSTRUCTIONS
P-7