Good Earth Lighting AC1213-BKG-07LF2-G Manual De Instrucciones

Hardware kit* / Trousse de quincaillerie*/ Kit de aditamentos*
LED tape light (x2) 18in/ (x2) 24in
Ruban lumineux à DEL (x2) 18in/ (x2) 24in OFF ON
Luz LED con cinta autoadhesiva (x2) 18in/ (x2) 24in
R
G B W
FLASH
STROBE
FADE
Remote control
SMOOTH
Télécommande
Control remoto
THIS LIGHT IS NON-CUTTABLE AND NON-LINKABLE
This product has a USB connector allowing quick and easy connection to televisions and laptop computers. The LED tape lights can also be plugged into an electrical outlet with a USB power
adapter (not included). DO NOT ALTER THE TAPE LIGHT. READ THE ENTIRE MANUAL PRIOR TO INSTALLATION. Verify package and hardware contents. Save these instructions.
IMPORTANT SAFETY INFORMATION
1. No parts are serviceable on this product. DO NOT cut the LED tape lights. These LED tape
lights are pre-connected and are not cuttable.
2. DO NOT INSTALL WHILE UNIT IS PLUGGED IN. DO NOT plug the USB cord into the power
source until installation is complete.
3. For electrical requirements, see back of driver label.
4. For INDOOR locations only.
5. DO NOT touch, operate, or install fixture while in contact with water. Not intended for
illumination of aquariums.
6. DO NOT mount over sinks or stoves.
7. NOT intended for recessed installation in ceilings or soffits. DO NOT run ANY cords behind
walls, ceilings, soffits, cabinets or a similar permanent structure where it may be
inaccessible for examination.
ATTACHING TAPE LIGHT TO SURFACE
Do not reposition tape light once it is
mounted. Doing so will reduce the
adhesiveness of the tape backing.
Once in place, allow the tape adhesive
to cure for 24 hours before use.
Select a location for the LED tape light and mark it. Verify that the USB cord reaches the
nearest USB port. Thoroughly clean the mounting surface with rubbing alcohol and
allow it to dry. DO NOT PLUG THE USB CORD INTO THE POWER SOURCE UNTIL
INSTALLATION IS COMPLETE. Remove the backing liner carefully so as to not
accidentally peel away the mounting glue of the LED tape light. Place the LED tape light
in the desired position. Carefully apply pressure to the entire length of the LED tape light
to ensure proper adhesion.
CONNECTING USB CORD
soft cloth. When cleaning the fixture, make sure the power is turned off. Do not spray cleaner directly onto any part of the
fixture or LEDs.
REMOTE CONTROL OPERATION
NOTE: When first turned on, the light will cycle through red, green and blue until a color is selected.
1. Remove the plastic battery tab on the remote control by pulling it
straight out of the remote.
2. The maximum operating distance of the remote control with new
batteries is approximately 20 ft. (7 m) with a direct line of sight between
the remote control and the IR receiver.
3. The battery used in the remote control is a CR2025 button cell, and will
need to be replaced at the end of its life cycle.
NOTE: Remote controller operation requires direct line of sight between
the remote control and the IR receiver.
BATTERY REPLACEMENT
When the battery is exhausted, use the instructions on the back of the remote
control to remove the battery and replace it with a new CR2025 battery.
Swallowing the batteries may lead to serious injury or death. If swallowed, go straight to a medical emergency room. Batteries may leak harmful liquids or ignitable materials or explode causing injury and product damage. Do not mix old and
new, or different types of batteries. Replace all batteries at the same time. Remove batteries from product if unused for extended amount of time. Replaced batteries should be disposed of properly. Keep batteries out of children's reach
USB Cord
Cordon USB
Cable USB
WARNINGS AND CAUTIONS
Once the LED tape lights are firmly in place, plug the USB connector into a television, computer laptop, or USB adaptor.
CARE AND MAINTENANCE:
Ruban lumineux RGB USB TV à DEL de 213,4 cm avec télécommande IR (Page 2)
Luz LED con cinta autoadhesiva USB de 213,4 cm RVA con control remoto IR (Página 3)
IR (Infrared) receiver
Récepteur IR (infrarouge)
Receptor IR (Infrarrojo)
* Actual hardware may differ from illustration.
* La quincaillerie incluse peut être différente de l'illustration.
* Los aditamentos reales pueden diferir de los que se muestran en la ilustración.
8. Tape light must be fully uncoiled for proper operation, and to prevent overheating.
9. This tape light is NOT expandable. Additional LED tape light lengths CANNOT be added.
10. DO NOT look directly at lighted LEDs for any length of time.
11. Use only insulated staples or plastic ties (not included) to secure the cords.
12. DO NOT use with an extension cord. Use a power strip with integral over current protection to
supply power to the fixture. NEVER use power strip unless the plug can be fully inserted.
14. DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT. If dimmer controls are present, remove
and replace.
15. If unfamiliar with electrical installations, contact a qualified electrician to install.
16. LEDs gradually emit less light over their lifetime.
INSTALLATION
Use included cord clips to hold cords
in between tape lights
Periodically clean the fixture and diffuser using a mild, non-abrasive cleaner and
The buttons located on the black background at the top of the remote
control, adjust the intensity and multi-color variations of the color
LED's output.
OFF ON
OFF ON
R
G
B
W
To dim, or brighten the color LED's, press, and hold down the dimming
FLASH
or brighten buttons until reaching the desired light output.
STROBE
Pressing any of the other color buttons will switch the
FADE
tape light to the color of the button pressed.
SMOOTH
FLASH STROBE
FADE SMOOTH
7 ft LED USB Tape Light RGB w/ IR Remote (Page 1)
Model / Modèle / Modelo #: AC1213-BKG-07LF2-G
FITS SCREEN SIZES
RANGING FROM 30IN.
TO 65 IN.
Use the "ON" or "OFF" buttons in this section to turn on
the color LED's.
The buttons at the bottom of the remote control, apply
festive, and changing light by cycling through color with
varying degrees of fades and jumping light changes.
Required/ Nécessaire
Se necesita
Cord clips (X5)
Clips de cordon (X5)
Clips de cordón (X5)