Idiomas disponibles
Idiomas disponibles
LOADING LABELS CONTINUED
Figure 5
4. Place the label roll between the hubs and click into
place. (See Figure 5)
NOTE: Do not thread label strip through any
rollers.
5. Drape the label strip across the labeler and center
it over the peel bar. The label strip should hang out
5-6 inches past the peel bar.
6. Close the cover.
7.
Squeeze and hold the trigger while feeding the
label strip under the roller and into the large slot
above the arrow until it stops/hits the back. (See
Figure 6)
8. Hold the strip in place and squeeze the trigger eight
times or until the label strip feeds through the rear exit.
9. Remove any loose labels.
Figure 6
PAGE 2 OF 9
INSTRUCTIONS CONTINUED
HUBS
PEEL BAR
CLEARING LABEL JAMS, CLEANING AND
LUBRICATION
1. Open the cover and remove the label roll.
2. Remove any loose labels from the inside of the
labeler. (See Figure 7)
LOOK
HERE
Figure 7
3. Pull up on the supply guide to expose the backing
paper path and remove loose labels. (See Figure 8)
4. Snap the supply guide back into place.
LOOK
HERE
Figure 8
5. Use a commercial adhesive solvent to clean
adhesive buildup.
6. Remove the ink roller to expose the print bands and
brush them off with a toothbrush.
7.
Reload, then close the cover.
LOOK
HERE
SUPPLY
GUIDE
Apply 1 drop of a commercial
100% silicone lubricant here.
0421 IH-4565
