Tabla de contenido
Idiomas disponibles
Idiomas disponibles
View the video of the MT Tumbler 500 MED in operation using this QR
code or, look for the video on our YouTube channel "Industrial medical
cannabis trimmer MT Tumbler 500".
To work with two units of the MT Tumbler 500/500 MED it's necessary to use the MT Tumbler 500 Rail and adjust the
inclination of the tandem according to the conditions of the product and the variety to process..
View the video of the MT Tumbler 500 MED Full System in operation
using this QR code or search for the video on our YouTube channel
"Medical Cannabis Trimmer MT Tumbler 500".
Quality control
Check the appearance of the flowers when leaving the barrel. If the flowers are not clean enough, this is usually because:
+The aspiration is too slow (the leaf collector is dirty/blocked).
+
The cutting blade is not properly adjusted.
+
The machine is dirty. It will need maintenance.
+
The spacing between the blade and the barrel is not correct.
+
The flowers have not been in the barrel for long enough. You are probably adding flowers too quickly. The machine
works best when the barrel is half-full.
Maintenance
For a good final result it is essential to perform periodic maintenance on the machine. The following steps for cleaning and
adjusting the blades are described below. If you work 100% with the machine it will be necessary to clean it every 4-5 hours
of work to have a good cut and performance.
Cleaning
To clean the support and the blade, you will need an 16-millimetre open spanner and a pressure washer.
Turn off the leaf collector and MT Tumbler 500 MED
1
X
by pressing the OFF buttons and disconnect both
from the power supply (G).
Remove the top protection. Pull the protection
3
inward slightly, open it 45 , and slide it through its
fastenings.
Separar el aspirador de la máquina extrayendo el
2
tubo de la boca de entrada de la máquina peladora.
Remove the hopper (B) by loosening the
4
fasteners (E).
20
Capítulos
Tabla de contenido
