Electrical Safety - Black and Decker BEGAS5800 Manual Del Usuario

Wear gloves when operating this
tool.
Do not use as a step.
Directive 2000/14/EC guaran-
teed sound power.

Electrical safety

Warning! This tool is double
insulated; therefore no earth wire
is required.
Always check that the power supply
corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Electric safety can be further improved
u
by using a high sensitivity 30 mA
Residual Current Device (RCD).
Features
This appliance includes some or all of the following features.
1. On/off switch
2. Direction selector
3. Overload protection button
4. Funnel
5. Stand
6. Collection bin
7. Adjustment knob
8. Plunger
Assembly
Warning! Before assembly, make sure that the appliance is
switched off and unplugged.
Attaching the wheels to the stand
(Fig. A)
Slide the sleeve (13) into the wheel (12).
u
Slide the wheel shaft (11) into the sleeve (13) and wheel
u
(12).
(Original instructions)
Slide the wheel shaft (11) into the washer (14) and insert
u
into the stand (5).
Secure the wheel shaft (11) into the stand with the screw
u
(15).
Secure the wheel (12) onto the wheel shaft with the spring
u
clip (10).
Secure the foot (16) onto the stand (5) using the screws
u
(17).
Repeat the above assembly on the revese side.
u
Attaching the motor unit to the stand (Fig. B)
Align the holes on the motor unit with the corresponding
u
holes on the stand (5).
Insert the screws (18) through motor unit and into the
u
stand.
Fitting the collection bin (Fig. C)
Slide the collection bin (6) into the stand (5) ensuring that
u
the safety switch locks securely.
Note: The unit will not operate unless the safety switch is
engaged.
Use
Warning! Let the tool work at its own pace. Do not overload.
Do not switch the appliance off before it is completely
u
empty, as it may clog and be difficult to restart.
Remove soil and stones from plant roots before shredding.
u
Firmly hold branches when feeding them into the
u
shredder.
Use the plunger (8) when required to feed material into the
u
shredder as shown in figure E.
Switching on and off (Fig. D)
Switching on
Set the direction selector (2) to left position.
u
Press the I button of the on/off switch.
u
Switching off
Press the O button of the on/off switch.
u
Warning! Do not operate the direction selector/switches
in sequence using abrupt motions. Sudden switching may
generate current spikes potentially damaging the shredder.
Clearing a blockage
If the appliance becomes jammed by branches which are too
thick or hard, or foreign bodies, the shredder will most of the
time release itself automatically. The rotating direction will
automatically reverse thereby releasing the material back
through the top. To return the rotation back to normal, proceed
as follows:
Switch off and wait until the cutting blade has stopped
u
completely.
Switch on again with the appliance set to forward rotation.
u
ENGLISH
7