Behringer MICROMIX MX400 Manual De Usuario página 2

2
MICROMIX MX400
Connect the power supply unit to your MX400 using the 12 V
(1)
connector. Connecting the power supply unit to the mains
automatically switches the MX400 on. To disconnect the unit
from the mains, pull out the main cord plug.
◊ ◊
When installing the product, ensure that the plug is
easily accessible. If mounting in a rack, ensure that the
mains can be easily disconnected by a plug or by an all-
pole disconnect switch on or near the rack.
Up to four line signal sources can be connected to these
(2)
1/4" TS connectors (INPUT).
◊ ◊
In case the volume level of one of the signal sources is
set too high, the input of the corresponding channel
may produce distortion!
The OUTPUT carries the MIX signal and is on a 1/4" TS connector.
(3)
This ON LED is illuminated as soon as the unit is connected to
(4)
the power.
Using the LEVEL controls you can set the output level of
(5)
each channel.
◊ ◊
High volume levels can damage your hearing or your
headphones. Please turn down all volume controls
to zero (all the way to the left) before you power
up the amp. Always make sure you use appropriate
volume levels.
SERIAL NUMBER. The serial number of the MX400 is located
at the bottom.
Applications
The following figure shows an example of how to use the
MicroMIX MX400.
Keyboards
MicroMIX MX400
XENYX X2222USB
Example: MX400 wiring
MICROMIX MX400
LINE IN
3