Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Figure 1:
correct installation running on house interior. Liquids
produced by gas condensation do not flow to the
exterior through the pipe joints
2.2 Exterior air inlet
For the fireplace draught to work correctly, the room must have an outside air inlet from the house exterior to the
room, that is at least sufficient to replenish the volume of air that comes out of the chimney flue.
In well insulated houses an air inlet must be fitted through the outer wall and if a vent is installed, it must be fitted
in such a way that it cannot be blocked.
Warning. In homes without the appropriate outside air inlet, extraction fans (e.g. Kitchen
extractors) can cause problematic reverse chimney draughts.
2.3 General installation recommendations
The installation of the appliance must comply with all local regulations, including those that refer to national and
European standards. In any case, the installation should be done by an authorised installer.
CARBEL will be responsible for the provided appliance, but in no case for the installation of the same.
Warning. -
and an inadequate maintenance might cause grave incidents.
Although the following describes an example installation to ensure good performance, it may not be ideal for your
circumstances.
Any installation should be done by an authorised installer. A faulty installation of this product
- Fumes exhaust pipe Ø 200.
2- Entry of air into the chimney
chamber by natural convection.
3- Entry of air into the cassette
convection chamber, drawn in by
fans.
4- Hot air outlet at the top of the
front blown by fans.
5- Hot air outlet driven by fans.
6- Hot air outlet of the chimney
chamber by natural convection.
7- Optional outlet for hot air to
other rooms, blown by fans.
8- Optional entry of air from the
outside used for combustion
Figure 2:
correct installation for parts running on house exterior.
Rain Water does not reach the inside of the pipe
through the pipe joints
23
Tabla de contenido
