Abicor Binzel iCAT Instructivo De Servicio página 39

iCAT WH
6.6 Attaching the ROBO WH torch neck
1
ROBO WH torch neck
1
Hand lever
2
Attaching the ROBO WH torch neck
Fig. 11
7 Operation
5
iCAT WH-ROBO WH
3
Clamping bracket (in
4
changeable body)
NOTE
• Do not move the hand lever position during the change procedure! This
will result in malfunctions. The open knife will cause the pre-tensioned
welding wire to expand and to become cut off when actuated next.
These wire pieces will block the locking mechanism and inevitably lead
to failures of the entire system!
1 Insert hand lever (2) through the sealing lips of the clamping bracket (4).
2 Move hand lever (2) forward toward the torch neck (1) through the
pressure point as far as it will go.
3 Insert torch neck into changeable body as far as it will go.
4 Move hand lever (2) through the pressure point as far as it will go and take
it out after locking.
Due to the fact that the iCAT WH is integrated into the welding process of the
torch, the operating steps are performed after the respective torch has been put
into operation. Please observe the operating instructions of the respective
ROBO WH welding torches.
2
3
4
Changeable body
5
7 Operation
EN - 17