Stopping Engine - Ducati DCS 5500R Manual De Instrucciones

How to switch between operating modes
1. Press down the left side of engine switch to
turn off the engine.
2. Pull out the top side of lock lever (1)
(step①), then pull the lock lever upwards to
unlock it (step②).
3. Pull out the cylinder shield rearwards and
remove it.
4. Pull the anti‐freezing window (2) out, then
turn it over and push it into the cylinder
shield again.
5. Reinstall the cylinder shield and lock it
securely.

Stopping engine

1. Release the throttle trigger to allow the
engine idling for a few minutes.
2. Press down the left side of switch.
7. SAWING
WARNING
• Before proceeding to your job, read "For
Safe Operation" section. It is recommended
to first practice sawing easy logs. This also
helps you get accustomed to your unit.
• Always follow the safety regulations. The
chain saw must only be used for cutting
wood.lt is forbidden to cut other types of
material. Vibrations and kickback vary with
different materials and the requirements
of the safety regulations would not be
respected. Do not use the chain saw
as a lever for lifting, moving or splitting
objects. Do not lock it over fixed stands. It
is forbidden to hitch tools or applications
(1) Engine switch
Owner's manual
to the P.t.o. that are not specified by the
manufacturer.
• It is not necessary to force the saw into the
cut. Apply only light pressure while running
the engine at full throttle.
• It is recommended that daily inspection
before use and after dropping or other
impacts to identify significant damage or
defects.
• Racing the engine with the chain seized in
a cutaway can damage the clutch system.
When the saw chain is caught in the cut, do
not attempt to pull it out by force, but use a
wedge or a lever to open the cut.
Guard against
This saw is equipped with a chain brake that
will stop the chain in the event of kickback if
operating properly. You must check the chain
brake operation before each usage by running
the saw at full the throttle for 1-2 seconds and
pushing the front hand guard forward. The
chain should stop immediately with the engine
at full speed, if the chain is slow to stop or
does not stop, replace the brake band and
clutch drum before use.
It is extremely important that the chain brake
be checked for proper operation before each
use and that the chain be sharp in order to
maintain the kickback safety level of this saw.
Removal of the safety devices, inadequate
maintenance, or incorrect replacement of the
bar or chain may increase the risk of serious
personal injury due to kickback.
English
41