Ducati DCS 5500R Manual De Instrucciones página 39

NOTE. Grip the starter handle, slowly pull out
the cord with your right hand until you feel
some resistance (the starter pawls grip), and
now quickly and powerfully pull the cord. Never
twist the starter cord around your hand.
9. When first firing occur, turn the choke knob
counter‐clockwise to open the choke.
NOTE. setting the choke manually can
temporarily set the throttle in a partially open
position to aid starting.
10. Hold the chain saw securely on the
ground, and repeat pull out the cord until
the engine start.
11. Pull up the front handle guard toward the
front handle to release brake. Then, allow
the engine to warm up with the trigger
pulled slightly.
WARNING
Before you start the engine, make sure the
saw chain is not contacting anything. Make
sure the chain brake always is activated before
each starting.
Hot starting:
To hot start the engine immediately after it has
stopped, follow steps 1-2-3-4-6 -7-10-11 of the
above procedure, making sure the primer bulb
is activated 2‐3 times only.
Checking oil supply
After starting the engine, run the chain at
medium speed and see if chain oil is scattered
off as shown in the figure.
Chain oil
Turn the shaft clockwise – Flow richTurn the
shaft counter‐clockwise – Flow lean.
The chain oil flow
can be changed
by inserting a
screwdriver in the
hole on bottom of
the clutch side.
Adjust according
to your work
conditions.
Owner's manual
The oil tank should become nearly empty by
the time fuel is used up. Be sure to refill the oil
tank every time when refueling the saw.
Checking functional of the clutch
Before each use, you shall confirm that there
is no chain movement when the chain saw
running at idling speed.
Adjusting carburetor
The carburetor on your unit has been factory
adjusted. but may require fine tuning due
to change in operating conditions. Before
adjusting the carburetor, make sure that
provided are clean air/fuel filters and fresh,
properly mixed fuel.
When adjusting, take the following steps:
IMPORTANT
Be sure to adjust the carburetor with the bar
chain attached.
1. H and L needles are only adjusted by
authorized persons. The adjustable range is
restricted within the number
Needle H: -1/4
Needle L: -1/4
2. Start engine and allow it to warm up in low
speed for a few minutes.
3. Turn idle adjusting screw (T) ounterclockwise
b
so that saw chain does not turn. If idling
speed is too slow, turn the screw clockwise
a
.
4. Make a test cut and adjust the H needle for
best cutting power, not for maximum speed.
English
Chain
oil flow
adjusting
shaft
39