Chain Oil; Operating Engine; Starting Engine - Ducati DCS 5500R Manual De Instrucciones

oil to be mixed.
2. Put some of the gasoline into a clean,
approved fuel container.
3. Pour in all of the oil and agitate well.
4. Pour in the rest of gasoline and agitate again
for at least one minute.
5. Put a clear indication on the outside of the
container to avoid mixing up with gasoline or
other containers.

Chain oil

Use special chain saw oil
all year round. Do not use
waste or regenerated oil that
can cause damage to the oil
pump.

6. OPERATING ENGINE

Starting engine

Cold starting: A "cold" start of the engine means
starting it after at least 10 minutes from when it
was switched off or after refueling.
1. Untwist the fuel cap and oil cap thoroughly,
but don't remove them from machine, just
hang up them.
2. Put fuel and oil into the fuel tank and the oil
tank to 80% of the full capacity.
3. Fasten two caps securely and wipe up any
fuel spillage around the unit.
4. Continuously push the priming bulb until fuel
comes in the bulb.
(1) Fuel tank opening (2) Oil tank opening
(3) Primer bulb (4) Choke knob
(5) Decompression valve (if equipped)
5. Turn the choke knob clockwise. The choke
will close and the throttle trigger will then be
set in the starting position.
NOTE. When restarting immediately after
stopping the engine set choke in the open
position.
6. Push in the decompression valve button. (If
equipped).
NOTE. When firing occurs, the decompression
valve will return to the close position
automatically, you should push in the
decompression valve button before each
starting.
7. Push the front handle guard down toward
the front to activate the chain brake.
8. While holding the chain saw securely on the
ground.