COMPONENTS {
}
1
A
B
FITTING {
}
2
E
4"
5"
10 cm
12 cm
APPLICATION {
}
3
J
①
C
F
G
5"
12 cm
M
K
②
③
L
BEFORE USING THIS DEVICE, PLEASE READ THE ENTIRE INSTRUCTION MANUAL. CORRECT APPLICATION AND CARE IS VITAL TO THE PROPER FUNCTIONING
OF THIS DEVICE.
Pregnancy and circulation; pulmonary, cardiovascular or skeletal conditions which have risk to be made worse as a result of
compression and/or pressure; unstable, displaced fractures.
If you experience any pain, swelling, sensation changes, excessive discoloration, irritation to the skin or any unusual reaction
while using this product, consult your medical professional. If any distortion of the support panels, fraying or deterioration of
lace cables is noticed, discontinue use.
LIST OF BASE PARTS
A. BELT WINGS (ONE EACH SIDE)
B. POSTERIOR (REAR) PANEL SECTION
C. PULL TAB
OPTIONAL ACCESSORIES
D
D. BELT PADS
f Begin by taking a measurement of the circumference of the patient approximately 1" (2.5 cm) superior to the trochanters or
widest part of the hips.
f Match the patient's size to the Sizing Chart below.
f Prior to applying the brace, make sure the support panels are separated by detaching the Pull Tab from the Belt Wings a pulling the
Posterior (Rear) Panel Section in opposite directions
f Attach the hook portion of the Posterior (Rear) Panel Section to the Belt Wings so the overall length
approximately 10" (26 cm) greater than the patient circumference
f NOTE: The Pull Tab may be oriented on either the right or left hand side of the patient, however the Belt Wing with the hook should
be secured on the opposite side of the Pull Tab and so the hook is at the distal end of the Belt Wing.
BELT PADS (OPTIONAL ACCESSORY)
f Slide Belt Wing through the elastic strap on the Belt Pad ensuring the anti-slip material is facing the patient and is oriented
horizonatally along the Belt Wing.
f Repeat on the opposite Belt Wing.
BRACE APPLICATION
f Apply the brace by centering the Posterior (Rear) Section
H
I
superior to the crease in the buttocks
f Wrap the Belt Wings anteriorly, approximately 1" (2.5 cm) above the greater trochanter (widest part of the hips) and secure the
hook and loop attachment on the anterior (front) side of the patient.
f Before tightening the brace make sure the Posterior (Rear) Section is positioned evenly on both sides of the patient. In order to achieve
optimal comfort and fit, it may be necessary to readjust and reposition the two (2) Belt Wings to the Posterior (Rear) Section.
f To apply compression, grasp the Pull Tab with the thumb and pull away from the body until reaching the desired compression, then secure
the hook portion of the Pull Tab to the Belt Wing.
B E LT W I N G T R I M M I N G I N S T R U C T I O N S ( O P T I O N A L )
f Detach the Pull Tab from the Belt Wings so the tension becomes loose, then reattach the Pull Tab on the Belt Wing close to the Posterior
Section.
(Figure L)
f NOTE: Do NOT trim excess material on the Belt Wings until proper fit has been confirmed.
B R A C E R E M O VA L
f Detach the Pull Tab from the Belt Wings so the tension becomes loose, then reattach the Pull Tab on the Belt Wings close to the
Posterior Section.
(Figure M)
f Detach the hook and loop connection on the Belt Wings and remove belt.
A D J U S T I N G P U L L TA B L E N G T H
f Remove Lace Spool from the Pull Tab Pocket.
f Wind lace around the spool to shorten the length of the Pull Tab. Unwind Lace from the spool to lengthen the Pull Tab.
f Insert Lace Spool back into Pull Tab Pocket.
U S E A N D C A R E : ( C L E A N I N G & S T O R A G E I N S T R U C T I O N S )
Hand wash in cold water, less than 86°F (30°C), using mild soap. Air dry.
NOTE: If not rinsed thoroughly, residual soap may cause irritation and deteriorate material.
Do NOT iron.
M AT E R I A L C O N T E N T S
Polyester, Nylon, Polyethylene, Silicon, Polycarbonate, Polyvinyl chloride, Elastic, Antimicrobial
F O R F I T T I N G T I P S O N T H I S E X O S ™ D E V I C E :
Visit the Exos™ Provider Center at: http://exosmedical.com/provider/formSIO or Scan the QR image with your
smartphone.
N
WA R R A N T Y:
DJO, LLC will repair or replace all or part of the unit and its accessories for material or workmanship defects for a period of
six months from the date of sale.
O
ENGLISH
I N D I C A T I O N S
Sacroiliac pain and dysfunction.
C O N T R A I N D I C A T I O N S
W A R N I N G S A N D P R E C A U T I O N S
C O M P O N E N T S { 1 }
S I Z I N G
SIZE
CIRCUMFRENTIAL MEASUREMENT
S/M
Less than 35" (89 cm)
L/XL
36" - 55" (91 cm - 140 cm)
F I T T I N G { 2 }
so the panels are separated approximately 4" (10 cm).
(Figure E)
(F)
of the SIO Belt is
(G)
, or approximately 5" (16 cm) greater on either end.
(Figure H)
(Figure J)
(Figure I)
A P P L I C A T I O N I N S T R U C T I O N S { 3 }
(Figure J)
at the posterior midline so the inferior portion of the belt is just
.
(Figure K)
(Figure K)
(Figure N)
(Figure O)
(Figure N)
Do NOT tumble dry.
Do NOT bleach.
INTENDED FOR USE ON A SINGLE PATIENT.