Ice Maker And Storage Bin; Refrigerator Features; Refrigerator Shelves - Sears Kenmore 106.5002 Manual De Uso Y Cuidado

Changing the Water Filter
A. Water filter cover door
1. Locate the water filter cover door in the base grille, and pull
open the filter door. The filter will be released and then be
ejected as the door is opened.
2. When the door is completely open, pull the filter straight
out.
NOTE: There may be some water in the filter. Some spilling
may occur. Use a towel to wipe up any spills.
3. Take the new filter out of its packaging and remove the
covers from the O-rings. Be sure the O-rings are still in place
after the covers are removed.
4. With the arrow pointing to the left (toward the filter cover
door's hinge), align the new filter with the filter housing and
slide it into place. The filter cover door will automatically
begin to close as the new filter is inserted.
5. Close the filter cover door completely in order to snap the
filter into place. You may need to press hard.
6. Flush the water system. See "Water and Ice Dispensers."

Ice Maker and Storage Bin

Allow 24 hours to produce the first batch of ice. Discard the
first three batches of ice produced.
The quality of your ice will be only as good as the quality of
the water supplied to your ice maker. Avoid connecting the
ice maker to a softened water supply. Water softener
chemicals (such as salt) can damage parts of the ice maker
and lead to poor quality ice. If a softened water supply
cannot be avoided, make sure the water softener is
operating properly and is well maintained.
Do not use anything sharp to break up the ice in the storage
bin. This can cause damage to the ice container and the
dispenser mechanism.
Do not store anything on top of or in the ice maker or
storage bin.
16
A
Turning the Ice Maker On/Off
To turn on the ice maker, lift open the ice maker door and
lower the wire shutoff arm to the ON position.
To manually turn off the ice maker, lift the wire shutoff arm
to the OFF (arm up) position and listen for the click. Ice can
still be dispensed, but no more can be made.
NOTE: Your ice maker has an automatic shutoff. As ice is made,
the ice cubes will fill the ice storage bin, and the ice cubes will
raise the wire shutoff arm to the OFF (arm up) position. Do not
force the wire shutoff arm up or down.
Removing and Replacing the Ice Storage Bin
1. Lift and hold open the ice maker door.
2. Lift the wire shutoff arm so it clicks into the OFF (up)
position. Release the ice maker door.
3. Lift up the front of the storage bin and pull it out.
4. Replace the bin by pushing it in all the way, or the dispenser
will not work.
5. To restart ice production, lift open the ice maker door and
push the wire shutoff arm down to the ON position.

REFRIGERATOR FEATURES

Your model may have some or all of these features.
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.

Refrigerator Shelves

(number of shelves varies by model)
Store similar foods together and adjust the shelves to fit
different heights. This reduces the time the refrigerator door is
open and saves energy.
To Remove and Replace a Shelf:
1. Pull the shelf forward to the stop. Tilt the front of the shelf
up. Lift to remove from the shelf supports.