Fitting The Wheels; Mounting Grip Rod; Installing The Grass Collection Box; Filling With Engine Oil And Checking The Oil Level - Deltafox DG-PLM 4019 P Traducción Del Manual De Instrucciones Original

GB

Fitting the wheels

1. Slide the wheel screw joints (32)
through the middle hole of the wheels
and the washer (33).
2. Screw the wheels into the desired
place. All wheels must be set to the
same height. There are three possible
positions: 25/45/65 mm

Mounting grip rod

Make sure that the Bowden cable
( 4) is not crushed during the
assembly of the grip handle.
Mounting the lower bars:
1. Insert the lower bars (6) into the
mount on the lawnmower hous-
ing (16).
2. Fasten the lower bars (6) using
the enclosed screws (24).
Mounting the bow-type
handle:
3. Attach the bow-type handle
(1) to the lower bars (6) using
the enclosed screws (23) and
knurled nuts (22).
4. Fasten the Bowden cable (4)
using a cable clamp (5) to the
bottom handle (6).
Installing the Grass Collection
Box
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
82
Assemble grass catchment
basket:
1. Push basket rods (27) into bas-
ket net (20).
2. Pull plastic loops (26) over bas-
ket rods.
Fixing the Grass Collection
Box onto the Equipment:
3. Lift up shock protection (20).
4. Hook the grass collection box
(19) into the mounting provided
for this (28) on the rear of the
equipment.
5. Release the impact protection
(20). It holds the grass collec-
tion box in position.
Dismantling/Empty out the
Grass Collection Box:
6. Lift the impact protection (20)
and remove the grass collection
box (19)
7. Empty catchment basket (see
chapter „Disposal / Environmen-
tal Protection") and re-install it.
Filling with Engine Oil and
Checking the Oil Level
Place the equipment on a level
base.
1. Unscrew the oil filler cap and dipstick
(18) and pour oil into the tank. The oil
tank holds 0.3 l oil. Use brand oil (e.g.
HD SAE 30 or 10W-30).
2. To check the oil level, wipe the dipstick
(18) on a clean cloth and replace it in
the tank until it stops.
3. After pulling it out, read off the oil
level on the dipstick. The oil level
should be in the marked area be-
tween the minimum and maximum
marks.