Connecting To A Power Source - Toro Power Sweep Manual Del Operador

Safety/Instruction Decals
Safety and instruction decals are located near
areas of potential danger. Replace damaged
or lost decals.
106-6483
95-5106
Save These Instructions
Assembly
2
Operation
Connecting to a Power
Source
Use only a polarized (i.e., one blade is wider than the
other), UL listed (CSA certified in Canada) extension
cord recommended for outdoor use. A polarized plug
will fit in a polarized cord only one way. If the plug
does not fit fully in the cord, reverse the cord. If it still
does not fit, purchase a polarized extension cord. Do
not change the plug in any way.
Extension Cord Length Minimum Wire Gage (A.W.G.)
100 ft.
150 ft.
Note: Do not use an extension cord over 150 feet.
If you do not fully seat the extension cord on the
inlet plug, the loose plug could lead to
overheating and cause a fire, possibly burning
you or others.
Ensure that you fully seat the cord on the plug
and use the cord lock feature to secure the cord.
Important: Check the power cord frequently during
use for holes in the insulation. Do not use a damaged
cord. Do not run the cord through standing water or
wet grass.
3351-153
16
14
Warning