Assembly - Alice's Garden OMBREC Manual De Instrucciones

EN

ASSEMBLY

Requirements for installation:
• The awning must be assembled and installed by at least two adults.
• All of the fasteners provided must be used so that the structure is sturdy.
• Warning: assembly and installation may be dangerous for the fingers. Please wear work gloves.
• Do not cut the safety restraints until the awning is fully installed on your wall.
TOOLS AND MATERIALS NEEDED
• Drill
• 16mm drill bit/ 7mm (if
installed on wood)
• Spanners (torque or com-
bination – 17mm)
• Mallet
INSTALLATION
The awning must be installed on a solid concrete wall, solid brick wall or solid wooden beam that is at least
11cm thick.
The height of the front bar when the awning is fully unfurled must be at least 2.5m.
Install the crank handle at a height less than 1.80m.
STEP 1: CHOOSE POSITION
You can choose the installation height of your awning, as long as the height of the front bar (when the awning
is completely unfurled) is at least 2.5m.
There is a simple formula to help you to calculate the height of your installation:
Your awning should ideally be angled at 80°,
so a factor of 0.17 must be used in the calculation.
For your information, if the slope angle was 60°, a
factor of 0.5 would be used.
*See p.41 «Adjusting the angle» to adjust the
angle of your awning.
So the formula is: Front bar height + (factor
x maximum projection length) = installation
height.
Example for an awning with 3m projection length:
2.50 + (0.17 x 3) = 3.01 m installation height for
brackets (with 80° slope angle)
Same example with 60° angle and awning with 2m
projection length:
2.50 + (0.5 x 2) = 3.50m
If you would like to install the awning above glass doors, please keep a minimum distance of 20cm between
the top of the door and the lower holes on the brackets.
36
• Hammer
• Spirit level
• Tape measure
• Pencil
• Two stepladders
Time needed:
45 minutes
2 people
80°
06/11/2019