Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1.
Flush through the supply pipes.
2.
Place the mixer including the sealing washer in
position on the sink.
3.
Slip the plastic washer, the slide washer, the
metall washer and collar over the hoses and
threaded base and tighten the collar nut by
hand. If there is not enough space, please use
only the slide washer and the metal washer
without the plastic washer.
4.
Tighten screws.
5.
Connect the supply pipes to the isolation
valves; cold right - hot left.
The hot and cold supplies must be of equal
pressures.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
( 1 MPa = 10 bar = 147 PSI )
Hot water temperature:
Recommended hot water temp.:
Rate of flow:
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15 MPa.
To adjust the hot water limiter on single lever
mixers, please see page _1b.
No adjustment is necessary when using a
continuous flow water heater.
English
Spare parts (see page 3)
1
1.1 screw cover
2
3
4
5
6
7
8
9
10
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
max. 80° C
65° C
13l/min 0,3 MPa
handle
flange
nut
cartridge cpl.
aerator cpl.
fixing set
connection hose
spout cpl.
sealing set
shut off unit
10490000
96338000
96468000
96461000
92730000
13913000
95049000
94082000
92830000
92646000
94849000
5
