Installation Steps - LUND 26410028 Instrucciones De Instalación

Installation Steps

Identify the (3) mounting locations for each bracket by looking under the driver side of the vehicle. Note the existing factory installed
1
Align running board brackets with studs. (Front bracket shown.) Install (3) washers and (3) locknuts at each mounting location.
2
3
NOTE: Actual application may vary slightly from illustrations.
studs. NOTE: For Super Cab only use front and rear mounting locations.
Front driver side shown
Hand tighten only at this point. Repeat for center and rear mounting locations.
Check boards for final position and tighten all bracket hardware
to 18-20 lb-ft. Repeat Steps 1-3 for passenger side.
Figure 1
Figure 2
Figure 3
Page 2 of 3