Tabla de contenido
After testing and acceptance of the working system, the user must adhere to the specifications of the documents
listed below:
OPERATING INSTRUCTIONS:
COBTROLS:
•
Opening;
•
Closing;
•
Step-by-step opening;
•
Emergency stop.
SAFETY DEVICES:
•
Sensitive ridge (contact safety);
Mechanical safety device;
•
Leaf movement flashing lights;
•
•
Photocell
The Zelio PLC manages the entire operation of the automation and from the display on the control panel it is possible
to view information messages and edit certain parameters.
The parameters can be edited through the use of buttons beneath the display. There are six buttons, four grey ones:
Z1,Z2,Z3,Z4; green OK button; white SHIFT button (see Annex 1 page 69)
Buttons Z1 and Z2 are used to navigate in the menu, buttons Z3 and Z4 to edit the parameters; the OK and SHIFT
buttons are system buttons (Annex 1 page 69).
The editable parameters are: Pre-flashing, automatic closing time, language. It is also possible to test the condition of
the safety devices (photocell and ridge).
Pre-flashing
Normally the flashing light begins to flash 1" before opening and 3" before closing to alert that movement of the leaf is
imminent. To deactivate this function and allow the door to operate instantly when the controls are pressed, press
button Z1 or Z2 until the display shows the "PRE-FLASHING" parameter, at this point press button Z3 to deactivate
the function or button Z4 to reactivate it.
The predefined value is ON.
Automatic closing
When the door is completely open, after 20" (preset) it will close again automatically.
To deactivate this function and not allow the door to close again automatically, press button Z1 or Z2 until the display
shows the "AUTOMATIC CLOSING" parameter, at this point press button Z3 to deactivate the function or button Z4 to
reactivate it.
To edit the closing time press and hold the white SHIFT button and press button Z4, release the SHIFT button and use
buttons Z2 and Z3 to change the closing time and the green OK button to confirm.
The predefined value is ON 20".
Language
This parameter allows you to change the language of the menu and messages.
To change the language press button Z1 or Z2 until the display shows the parameter "LANGUAGE" press Z3 to access
the submenu, press Z1 and Z2 again to scroll the languages. To confirm the language press Z4.
INSTRUCTIONS FOR USE
PLC PARAMETER EDITING
16
Tabla de contenido
